Oreck U2251 manual Replacing Edge Brush, Using an Oreck Fresh Air Tab, Stuffing or Blockage

Page 7

E N G L I S H

If a previous adjustment has already been made and bristle height does not extend above the baseplate, a new brush assembly should be ordered.

IMPORTANT: Unless the brush is worn as indicated above, both bearings must be in the “NEW” position. When rotating, both bearings must be in the “OLD” position. Unmatched settings can cause damage to the unit.

OLDNEW

15

16

17

18

Replacing Edge Brush

WARNING: Unplug cord from electrical outlet before servicing.

Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush. Remove both edge brushes and replace with new ones. Replace both screws and tighten.

Using an Oreck Fresh Air® Tab

Your ORECK U2251 vacuum cleaner has a special ORECK FRESH AIR® tab pocket. This pocket is located inside the outer cloth bag in the area where the disposable filter dust bag attaches to the intake tube. Insert tablet in pocket if desired.

Stuffing or Blockage

IMPORTANT: On plush and new carpets, stuffing may occur inside the the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:

WARNING: Unplug cord from electrical outlet before servicing.

19Check for blockage at the mouth of the intake opening. If there is blockage, remove it with long-nose pliers,

a screwdriver or coat hanger. If you can not reach the blockage, remove baseplate. Remove the baseplate by removing 5 screws (see “Adjusting or Replacing Brushroll”).

20If the blockage is not at the base, remove lower tube. Unhook bag spring, releasing bottom of bag.

21Twist lower collar counterclockwise to slide up. Pull tube out of base.

22Check for blockage. If blockage is in the tube, remove with a coat hanger.

23If tube is not blocked, look into fan housing. Remove debris with long-nose pliers, a screwdriver or coat hanger.

21To reassemble, check O-ring on tube, and replace if damaged. Replace tube by first lining up slot at base of tube with tab inside fan housing. Insert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place. Reattach bag spring.

24Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly.

Note: If the above actions do not correct the problem, contact an Oreck authorized service center or call the customer service center.

US: 1-800-989-3535 Canada: 1-888-676-7325

19

20

21

22

7

23

24

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Powerful, Lightweight Upright Vacuum Household Use Only Safety Enjoy Call Click VisitRead ALL Instructions Before Using this Vacuum Cleaner General WarningsParts List ContentsOperation Operating the U2251 Assembling the Handle TubeOperating Instructions Lubrication Disposable Filter Dust BagsCeloc Filtration System BeltReplacing Worn Belt Adjusting or Replacing BrushrollBAG Installation Replacing Disposable Filter Dust BagReplacing Edge Brush Using an Oreck Fresh Air TabStuffing or Blockage Parts AccessoriesReplacement Parts Customer Service HotlineWarranty Aspiradora vertical potente y liviana Sólo para uso casero Seguridad DisfruteVisite Advertencias GeneralesOperación ContenidoLista de piezas Manejo del U2251 Ensamblaje del tubo-mangoInstrucciones de operación La correa Información GeneralBolsas para polvo con filtro desechables Sistema de filtración CelocRetiro DE LA Bolsa Cómo reemplazar una correa desgastadaInstalacion DE LA Bolsa Viejonuevo Reemplazo del cepilla orilladorUso de una tableta Oreck Fresh Air Relleno o bloqueoLínea gratuita de servicio al cliente PiezasAccesorios Piezas de repuestoGarantía Aspirateur-balai puissant et léger Avertissements Généraux Sécurité Appréciez Appelez Cliquez RencontrezListe de pièces Table des MatièresUtilisation du U2251 Assemblage du tube de mancheInstructions dutilisation Lubrification Sacs à poussière jetables en papier filtreSystème de filtrage Celoc La courroieInstallation d’un sac Remplacement du sac à poussières filtrantRemplacement d’une courroie usée Réglage ou remplacement du balaiUtilisation d’une tablette Oreck Fresh Air Remplacement du cylindre brosseurBlocage ou bourrage Dépannage AccessoiresPièces de Remplacements Service à la Clientèle USA 1-800-989-3535 CanadaOreck Garantie

U2251 specifications

The Oreck U2251 is a compact, lightweight upright vacuum cleaner that stands out for its powerful performance and user-friendly features. Weighing in at just 8 pounds, it is designed for effortless maneuverability around the home, allowing users to easily carry it up and down stairs or move it from room to room without straining their backs.

One of the standout features of the Oreck U2251 is its powerful suction capability. It employs a high-speed, balanced brush roll that effectively picks up dirt, debris, and pet hair from a variety of surfaces, including carpets and hard floors. This efficient cleaning system ensures that dirt is captured rather than simply pushed around. The U2251 also includes a flexible hose and a range of onboard tools, making it versatile for above-floor cleaning and reaching tight spaces.

The Oreck U2251 is equipped with advanced filtration technology, featuring a top-access bag system that captures dust and allergens. The hypoallergenic inner bag locks in dust, preventing it from escaping back into the air, which is particularly beneficial for allergy sufferers. The bag also has a large capacity, allowing for longer cleaning sessions without the need for frequent changes.

Another notable characteristic is the Oreck U2251's design. The vacuum is built with user convenience in mind, featuring a low profile that allows users to clean under furniture with ease. Its ergonomic handle provides a comfortable grip, reducing fatigue during extended cleaning tasks. Additionally, the vacuum has a 40-foot power cord, allowing for extended reach without the hassle of changing outlets frequently.

The Oreck U2251 also boasts durability, with a warranty that reflects the manufacturer's confidence in their product. Its simple yet effective design ensures that it remains easy to maintain and repair, further extending its lifespan.

Overall, the Oreck U2251 is an excellent choice for those seeking a lightweight yet powerful vacuum cleaner. With its advanced cleaning technologies, user-friendly features, and robust design, it fits the needs of various households, making cleaning tasks more efficient and less of a chore.
Top Page Image Contents