Samsung HT-RP16R/XFO manual Setting the Speaker Mode, Stop or no disc, Mode, press, Menu button

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.

Setting the Test Tone GB

Use the Test Tone feature to check the speaker connections.

In Stop mode,

1 press MENU

button.

In the Speaker

3 Setup, press the ENTER button again.

Press Cursor 2 button to move to

‘Audio’ and then press ENTER button.

Press Cursor , ,

4 , buttons to move to the desired speaker and then press ENTER button.

•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.

•For L and R, the mode is set to SMALL.

1	In	Stop or no disc	2	Press Cursor
				button to move to
	mode, press
				‘Audio’ and then
	MENU button.
				press ENTER button.

Press RETURN button to return to the previous level.

Press MENU button to exit the setup screen.

Press Cursor button

3 to move to ‘TEST TONE’ and then press ENTER button.

•The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in order.

If the ENTER button is pressed again at this time, the test tone will stop.

SETUP

SMALL : Select this when using the speakers.

NONE : Select this when no speakers are connected.

Alternate method: press the TEST TONE button on the remote.	L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
	R: Front Speaker (R)	SL: Rear Speaker (L)	SR: Rear Speaker (R)

Note

•• Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 53).

45

Press TEST TONE button.

•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

To end the test tone,

press TEST TONE button again.

Multi-Channel Pro Logic Mode

Start

46