Cleaning and Maintenance
Before cleaning or maintaining, turn the appliance off by pressing the ON/STAND BY button (A) or button (I) on the remote control and always unplug the appliance from the socket.
CLEANING THE CABINET
You should clean the appliance with a slightly damp cloth then dry with a dry cloth.
For safety reasons, never wash the air condi- tioning unit with water.
Precautions
Never use petrol, alcohol or solvents to clean the appliance.
Never spray insecticide liquids or similar.
CLEANING THE FILTERS
To keep your air conditioning unit working effi- ciently, you should clean the dust filter every week of operation.
The filter is housed in the intake grille.
When removing the evaporator air intake grille (7), do not touch the evaporator’s metallic wings because they are very sharp and could be dangerous.
To clean the filters, proceed as follows
1.Remove the intake grille by rotating outwards (Fig. L).
L
2.Remove the dust filter by detaching it from the grille (Fig. M). Remove 3M® electrosta- tic filter if it is mounted.
3M® electrostatic filter
dust filter
intake grille
M
Use a vacuum cleaner to remove the dust collected on the filter.
If the dust filter is very dirty, immerse in warm water and rinse a number of times.
The water should never be hotter than 105 °F (40°C).
After washing, leave the filter to dry.
To replace, put the filters back in the intake grille then attach the intake grille to the appliance.
Do not wash the 3M® ectrostatic filter when it is
START OF SEASON CHECKS
Make sure the power cord and plug are undamaged and properly grounded.
Follow the installation instructions precisely.
END OF SEASON OPERATIONS
Place the appliance in
To completely empty the internal circuit of water, press the MODE and SPEED buttons simultaneously for a few seconds without removing the condensation tank (8).
.
1 | PUSH |
|
2
N
The water in the internal circuit will drain into the condensation tank (8) or through the continuous drain
hose (21) if connected (Fig. N)
Make sure the other end of the hose is near a suitable drain.
When completely drained, disconnect the continuous drain hose.
Clean the filters and dry thoroughly before putting them back.
17