DeLonghi PAC600T Selecting functions, AIR Conditioning Functions, Cool JET, Problem Warning Light

Selecting functions

AIR CONDITIONING FUNCTIONS

To turn the unit on in air conditioning mode, proceed as follows:

1.Press the ON/OFF button 11 (the signal light 10 will come on).

2.Rotate the function selector 19 dial anti- clockwise:

•Place the function selector in the HIGH pos. to operate the unit in air conditioning mode at maximum fan speed, after 3 minutes the signal light 15 will come on ).

•Place the function selector in the LOW pos. to operate the unit in air condtioning

mode at minimum fan speed (the signal

light 21 will come on, and then, after 3 minutes the signal light 16 will come on ).

3.Now set the required temperature by rota- ting the room thermostat dial 20 .

Note

The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. When the desi- red room temperature has been reached, slowly turn the thermostat in a clockwise direction until it arrives at the position where a click can be heard. The signal lights 15 (or

16) will turn off.

The temperature selected in this way will automatically be regulated and maintained, and save energy. When regulating the ther- mostat, the air conditioning function is tem- porarily interrupted and the unit continues to operate in fan only mode. In this way, the appliance keeps the air temperature within the room even.

Delay on Start Up

1.A special safety device will delay the start of air conditionig by approximately 3 to 5 minutes when switching between func- tions or on initial start up.

2.You may also experience a slight delay between changing from one function to another.

10

COOL JET

The cool jet mode was conceived to provide the appliance with a greater cooling poten- tial. This is particularly useful when you want to bring the temperature of a very warm room quickly down to a more comfortable level. In this case:

Make sure that the tank is full of water (see page 8);

Make sure that the function selector switch

19is in the HIGH position.

Press the Cool jet button 22 .

After reaching the desired temperature, you can release the Cool jet button and reposi- tion the selector switch to the LOW pos. Doing so will make the operation quiter.

VENTILATION/FILTRATION

Rotate the function selector 19 clockwise.

•Press the ON/OFF button 11 (the signal light 10 will come on).

•Place the function selector on the “FreshZo-

ne” position and choose the desired fan speed (min/max). The signal light 17 or

18will come on).

PROBLEM WARNING LIGHT

The lighted pilot light 23 indicates that

the safety device of the pressure switch has switched on. In this case the appliance is deactivated. To restore the proper functio- ning of the appliance, eliminate the possible causes of the problem and press the restore button 6 .

The causes may be:

1)The exhaust hose forms a siphon in which condensation water has accumulated: in this case, it is necessary to drain the accu- mulated out of the machine, outwards (never towards the air conditioner) and eliminate the siphon on the hose.

2)The exhaust hose is obstructed: eliminate the obstacles which obstruct the expulsion of the air to the outside.

If, after having repositioned the drainage tube, the machine still does not start up, the problem might be more complicated (ex.: obstructed ventilation fan) and could require the assistan- ce of the Authorised Service Centre.