Bionaire BH3930 manual Unit Operation Without Remote, Assembly Instructions, Timer Function

2.When in "Auto" mode, press the (-) button on the remote to decrease the "Set" temperature. The unit scrolls one digit at a time in a continuous loop.

UNIT OPERATION WITHOUT REMOTE

A. Remote and Unit are OFF:

1.Press the Mode button on the unit the first time. The "Low" light illuminates and the unit runs in "Low" mode. The power light turns on.

2.Press the Mode button a second time to run in "High" mode (1500 Watts).

3.Press the Mode button a third time and the unit shuts off.

3.Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps.

Note: The power light will remain lit during operation

ASSEMBLY INSTRUCTIONS

Wheel Assembly

Tools required for assembly: Phillips head screwdriver

Carefully unpack your Bionaire® heater from the box (it is recommended to save the box for off-season storage). You will find the following pieces:

1. Four casters (wheels) 2. Four screws 3. Two caster (wheel platforms)

Figure 3

WARNING DO NOT ATTEMPT TO OPERATE THE HEATER WITHOUT THE WHEELS IN PLACE

LOW (1000 Watts)

high

low auto

mode

HIGH

(1500 Watts)

AUTO

Casters (Wheels)

X 4

Caster

Platform

1.	Make sure the unit is
	unplugged. Using a slotted
	or Phillips head screwdriver,
	attach two casters to each
	caster platform.
2.	Carefully turn the unit over
	so the caster platforms can

MODE

Note: The "auto" light only illuminates when the unit is set to "auto" mode by the remote.

B. Remote is ON and Unit is ON:

1.Press the Mode button on the unit. The unit will then switch "Modes"; either from "Low" to "High", "High" to "Off" or "Auto" to "Off" . The unit’s lights will reflect the change. The Remote will display a different mode – the mode in which it was left. If a button is pressed on the Remote, the Remote’s signal will override the "Mode" on the unit and the two will be back in sync.

TIMER FUNCTION:

Using Timer to turn unit off

1)Hold mode button for 2 seconds to unlock remote.

2)Push + and - together.

2.1) "timer" turns on. 1 Hr appears on the screen.

3)Push + or - to adjust the number of hours the unit will run before it automatically shuts itself off.

Fig. 1

be attached.

3.Slide the caster platform into the bottom of the plastic end cap, following the grooves (shown in Fig. 1).

4.Repeat this sequence on the other side of the heater, making sure both sides are secure.

5.Return the console to its upright position.

FIRST USE ONLY:

1.Put batteries into Remote. The "Room" temperature is displayed at all times. (Use 3 AAA batteries only, do not mix alkaline and heavy duty batteries)

2.Plug unit into outlet. The first time the unit is plugged in, it will beep every two seconds until it is synced with the remote. To sync unit with remote follow the below steps:

Unlock remote. (This must be done before each use of the remote) To Unlock remote, hold down the mode button for 2 seconds until the lock symbol disappears from the screen. Once the remote is unlocked, press the mode button again and the unit will quickly beep 5 times telling the user the signal was received. DO NOT

7 4