PSP 1000/2000/3000 users
∙ Ensure you have a memory stick in your PSP with a minimum capacity of 3MB.
∙ Remove any UMD discs.
∙ Connect your PSP to your PC using the provided USB cable. ∙ Switch on your PSP and wait for the crossbar to appear.
∙ Navigate using your directional pad to the “Settings” bar and select “USB Connection”.
3.Your PSP is now connected to your PC and will appear as a removable disk drive (it may be shown as any drive letter from ‘D’ to ‘Z’). The setup utility will automatically detect your PSP and ask you to confirm that it has detected the correct drive letter.
If for some reason the correct drive letter is not detected you can select it yourself by clicking the “I’ll Select My PSP Drive” button. Use the “Next” button to select the correct drive letter and confirm by selecting “Yes this is my PSP drive” to proceed with the installation.
4.The setup utility will now install Action Replay to your PSP memory stick or system memory if you own a PSP go.
5.Exit USB mode on your PSP and follow the steps below which are relevant for your PSP version:
PSP go users
Navigate using your directional pad to the “Game” bar, select “System Storage” and then select “Action Replay”.
PSP 1000/2000/3000 users
Navigate using your directional pad to the “Game” bar, select “Memory Stick” and then select “Action Replay”.
6.Action Replay at this point will run but only in a ‘Demo’ mode. It needs to run this once in ‘Demo’ mode to obtain your PSP’s ID. To activate Action Replay fully you will now need to exit Action Replay and
7.Now on your PC, ensure you have
8.Once the installation is complete this will be confirmed by the setup utility, when prompted to do so disconnect your PSP and exit USB mode.
You are now ready to start Action Replay, please read the following section
“Using Action Replay”.