Charnwood Country 14B installation instructions PRE Lighting Check, Commissioning

re-tighten the locking nut. Ensure that the flap opens and closes freely as the knob is turned.

PRE LIGHTING

CHECK

Before initial lighting the following points should be checked :-

1.The bottom grate bars must all be fitted and should move freely and easily when the riddling mechanism is operated.

2.The plates round the sides and back of the grate must be in position and sitting correctly.

3.The throat plate must be fitted in the roof of the appliance and should be checked to ensure that it has not become dislodged in transit. The method of location and positioning of the throat plate is shown in Fig. 3.

COMMISSIONING

On completion of the installation and after allowing a suitable period of time for the fire cement and mortar to dry out, the stove should be lit and checked to ensure that smoke and fumes are taken from the appliance up the chimney and emitted safely. Also check all joints and seals.

The central heating pump should be adjusted to give the correct water flow against the circuit resistance and the system should be correctly balanced.

On completion of the installation and commissioning please leave the operating instructions with the customer and advise on the use of the appliance and any controls on the system.

Flue connection may						Boiler tappings are 1" BSP Female
be Top or Rear
	136				601		ø154		136
						357
789			731						451
683									608
						340
		389		570
			616					136	344

Country 14B Dimensions (All dimensions are in mm)

Page 8

Country 14B 09/03