Dimplex PLX 500, WTI 500 Safety Overheat protection, Cleaning, After Sales Service, TX Models

Page 3

Automatic Operation

Set the timer switch to position. The panel will now operate during set ‘ON’ periods under the control of the thermostat.

To set the timer’s ‘ON’ and ‘OFF’ periods:

Safety - Overheat protection

For your safety this appliance is fitted with a thermal cut-out. In the event that the product overheats for some reason, the cut-out prevents excessive temperatures on the product by cutting the power to the heater. Once the heater has cooled

1.Using your finger tip or the tip of a pencil, push in as many segments as necessary around the dial, according to the times you don’t require heat – see Fig. 6. Each segment pushed in switches the heater OFF for that part of the hour. All other segments will be ‘ON’.

14 13 12

11

Fig. 6

down, it will reset automatically, it will continue to cycle on and off automatically until the reason for overheating is removed.

Cleaning

Before commencing cleaning, unplug the heater and allow it to cool. Disconnect the electricity supply to the appliance.

2.You can select as many ‘ON’ periods as you like, within the 24-hour day. The settings will repeat every day until changed.

3.To change ‘ON’ and ‘OFF’ times, simply push in any ‘ON’ segments you wish to cancel and pull out new ‘ON’ segments as required.

Note: On TI models each segment on the timer represents 20 mins.

TX Models

TX Models are fitted with 7 day programmable timers. In all other respects they are identical in installation and operation to 24 hour timer operation on TI models.

1. Setting the Time

The current day and time is set by rotating the timer dial clockwise until the correct day and time is indicated opposite the datum mark.

2. Automatic Operation

Set the time switch to the symbol. Select the days and times you require the heater to come on by pulling out the appropriate segments. Each segment represents a 13/4 hour period for the day indicated. The timer may be set to give as many ‘ON’ periods of any length required in multiples of 13/4 hours. The programme will repeat itself every 7 days until changed.

The programme may be over-ridden at any time by switching

to or and can be reinstated by switching back to setting.

The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not use abrasive cleaning powders or furniture polish, as this can damage the surface finish.

To release heater from the wall bracket for cleaning or redecoration, depress latch on both brackets (see Fig. 2) and hinge forward.

After Sales Service

Your product is guaranteed for two years from the date of purchase.

Within this period, we undertake to repair or exchange this product free of charge provided it has been installed and operated in accordance with these instructions.

Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.

Should you require after sales service you should contact our customer services help desk on 0870 727 0101. It would assist us if you can quote the model number, series, date of purchase, and nature of the fault at the time of your call. The customer services help desk will also be able to advise you should you need to purchase any spares.

Please do not return a faulty product to us in the first instance as this may result in loss or damage and delay in providing you with a satisfactory service.

Please retain your receipt as proof of purchase.

Image 3
Contents Models Watt Important Safety AdviceElectrical GeneralWall Mounting Access to the controlsOperation TI and TX Timer Models Using the TimerTX Models Safety Overheat protectionCleaning After Sales ServiceEnergy Saving Tips Other Energy Saving Tips for Around the HomeEnergy efficiency tips for heating and hot water