Samsung VCU9380V3K/SML manual Maintain tools and filter, Check Rotating Floor Brush and Drive Belt

Page 14

Maintain tools and filter

Check Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner’s rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair, and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.

1.Unplug cleaner from electrical outlet.

2.Recline handle and turn vacuum cleaner over so

bottom side is up.

3. Remove the six screws as shown with a phillips head screwdriver. Lift the brush cover off.

4. Grasp rotating floor brush at both ends and lift.

5. Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends.

6. Clean strings, hair and other debris from motor pulley and drive belt areas.

7. Check drive belt carefully for wear, cuts or stressed areas.

8. Check air passageway for obstructions. Remove debris from this area.

Rotating drum-brush could cause the fringe of a rug to become tangled within CAUTION cleaner.

Use caution and turn off the drum-brush when vacuuming throw rugs with fringe.

Replace Drive Belt

1.Unplug cleaner from electrical outlet.

2.With rotating floor brush removed from vacuum cleaner grasp old drive belt and remove from motor

pulley. Discard old drive belt.

3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles.

4.Place ends of rotating floor brush down into slots on sides as shown.

5.Turn rotating floor brush by hand several times in the direction of motor pulley. If properly installed, drive belt will center itself on rotating brush crown.

6.Reposition brush cover and screws. Tighten screws securely.

14_ Maintain tools and filter

Image 14
Contents Product accessories Carton contentsSafety information Safety InformationIMpORTANT Safety INSTRucTIONS For Residents of the United Kingdom onlyContents INTROducTION Assembling the cleanerClEANERh Tg INl Accessories Assembling the cleaner TOOl STORAgE ClEANERh Tg OpERATIN Operating the cleanerPOwER Foot hEIghT AdjuSTMENT CORd RElEASEPower switch/Power foot brush roll switch Circuit breaker Reset switchHandle Positions How to operatePlug cord into electrical outlet. Press power on/off button Step on handle release lever to lower handleUSINg AccESSORIES Cleaning toolsLongreach cleaning TOw h 03OpERATECheck Rotating Floor Brush and Drive Belt Unplug cleaner from electrical outletMaintain tools and filter Replace Drive BeltSmart Inverter FId SlANPowered hand toolTurbine brush Brushbar ReplacementEMpTYINg ThE duST bIN Cleaning the dust bin & Re-assembling the dust bin Check the assembling order when Re-assembling the filter WAShINg YOuR FIlTERVacuum cleaner won’t Pick up / Loss of suction Trouble shootingVacuum cleaner won’t turn on Dust escaping from the vacuum cleaner
Related manuals
Manual 20 pages 5.82 Kb