Samsung WF7702NAW/XEU manual Washing for the First Time, Putting Detergent in the Washing Machine

Page 9

What is the “Child Lock” function?

If you press the “Child Lock” button(Spin+Function button) longer than 2 sec during operation, this function is selected.

If once this function is selected, no change can be done until the end of laundry.

Press the “Child Lock” button(Spin+Function button) longer than 2 sec to cancel the function.

WM STOPS THE CURRENT STEP OF THE CYCLE OR DOES NOT PROCEED TO THE NEXT STEP OF WASHING (INDICATION OF REMAIN TIME ON LED DISPLAY MAY INCREASE).

Your new washing machine is equipped with Fuzzy Logic system, which not only sets the optimum level of water and other parameters of washing, but also controls the washing process as well as makes necessary corrections in order to provide better washing results. In the above- mentioned matter, the Fuzzy Logic system has detected deviations in washing cycle such as: high quantity of detergent at the end of the cycle, high vibration level while spinning, etc.You can adjust existing wash programs, i.e. change wash temperature and spin speed. After detection of such abnormalities, the washing machine is suspending the normal course of program in order to normalize these parameters and continue the cycle. Fuzzy logic system makes 7 attempts to eliminate such deviations. If it is impossible to normalize the above mentioned deviations by Fuzzy Logic system, you will see the corresponding indication on LED lamps. (see chapter “Troubleshooting”) The operation of Washing machine that corresponds to above- mentioned scheme is considered to be normal.

WASHING FOR THE FIRST TIME

Before washing clothes for the first time, you must run a complete cycle without clothes. To do this:

1.Press the (On/Off ) button.

2.Pour a little detergent in the detergent drawer .

3.Turn on the water supply to the washing machine.

4.Press the Temp button repeatedly until 40˚C is displayed.

5.Press the Start/Pause button.

This will remove any water from the manufacturer’s test run remaining in the machine.

PUTTING DETERGENT IN THE WASHING MACHINE:

1.Pull out the detergent drawer.

2.Add laundry detergent into compartment .

3.Add softener into compartment (if you desire).

4.Add prewash detergent into compartment (if you desire).

Washing a load of laundry _8

02 Washing a load of laundry

Image 9
Contents Washing Machine Important Safety Symbols and Precautions Safety informationBefore Using the Appliance Safety InstructionsSafety information Contents Overview of the Washing Machine Unpacking the Washing MachineSelecting a Location Cover topAdjusting the Leveling Feet Installing the washing machineConnecting the Water Supply Hose Removing the Shipping BoltsLn a sink drain pipe branch Plugging in the MachineOverview of the Control Panel Washing a load of laundryWhat is the Child Lock function? Washing for the First TimePutting Detergent in the Washing Machine When the cycle is finished Washing Clothes ManuallySelecting Options Load Capacity Washing Tips and HintsRepairing a Frozen Washing Machine Cleaning the ExteriorMaintaining the washing machine Cleaning the Water Hose Mesh Filter Cleaning the Debris FilterProblems and Solutions TroubleshootingUnderstanding Error Messages Programme chart Programme ChartType of wash Appendix Fabric Care ChartElectrical Warnings Protecting the EnvironmentDeclaration of Conformity SpecificationMemo Questions or COMMENTS?
Related manuals
Manual 1 pages 23.43 Kb