Automatic Ice Maker does not work | Samsung RF263BEAESP/ML instruction

Before calling service

If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)

1. Automatic Ice Maker does not work

6. Water dispenser dripping (On some

models)

10. Display

13. Moving and Installing

•Allow your refrigerator to operate and cool down for 24 hours (1 full day) be- fore the ice maker starts producing ice.

•To fill the ice bucket to maximum ca- pacity, dispense a few cubes 8 and 16 hours after installation.

•If ICE OFF is lit, the ice maker will not make ice.

•To activate the ice maker, press the ICE OFF but-ton on the control panel so it is no lon- ger lit.

• If the water line is not inserted into the coupler

properly, air could penetrate into the water line

causing water dripping from the water dispenser.

• CAUTION : Insert the water line into the coupler com-

pletely and slide in the clip at the end of the coupler.

Red Clip (1/4")

Cabinet

Tube

The display may differ depending on models.

For details, refer to the user manual “Using the control panel.

• Recommended Temp Settings : 0ºF(-18ºC) for

• When installing, servicing or cleaning behind the

refrigerator, be sure of the following:

• To protect your floor's finish when moving the

refrigerator, cut a large section of the cardboard

carton and place under the refrigerator where

you are working.

• Pull the unit straight out and push back in

straight after finishing.

2.Slow Ice cube freezing

•Check if the ice bucket is completely

inserted. (On some models)

• Freezer temp may not be enough; set it to -2ºF(-19ºC) or lower.

3.Small or bubbled ice cubes or Slow water dispensing

•If the water filter is clogged, small or bubbled ice cubes may be produced.

•Replace the water filter cartridge with a new one.

4.Water ﬁlter replacement

•Slowly turn the water filter 90° clockwise so it is aligned with the printing mark on the cover, lock- ing the filter in position.

Make sure to align the water filter label mark with center of cover fil- ter printing as illustrated.

•If you are in trouble of inserting the

water filter as high pressure of water, shut off the water supply valve. For details, refer to the “Chan- gig the water filter” section of the User Manual.

	After installation or when replacing the
	water filter, dispense at least
	1 gallon (2~3minutes) of water to	PUSH 
	remove trapped air from the water line.	PUSH 
	remove trapped air from the water line.
	Otherwise, water may drip after dis-
	pensing water. (On some models)

5.Water is not cool enough (On some models)

•The first glass of water may not be cold enough because the stored water in the water valve has not cooled completely. Dispense several glasses of water and then it would be cool.

Dispenser

Door Tube

1.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.

2.Insert the clip in the install pack and check that it

holds the line firmly.

Center of transparent coupler

clip A (1/4”) (6.35mm)

7.Fridge or freezer Compartments are warm

•Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach to the set temperature.

•Also, when you put room temperature or warmer food into your refrigerator, it may need an additional 24 hours for the fridge to reach the set temperature.

8.Moisture forms on outside/inside of refrigerator

•Wipe off the condensation with a dry towel (This may occur during hot and humid seasons.)

•If the condensation occurs on the doors, turn off the Energy Saving function.

•If you open the doors frequently or for too long, it may cause moisture inside the fridge.

9.Noise Clicks, Pops, Cracks, Snaps

•These noises may be heard occasionally inside the refrigerator. This is normal. This sound occurs when various items contract or expand while temperatures are changing; especially during defrosting. This may also occur when electronic devices including the ice maker are operating.

freezer and 37ºF(3ºC) for refrigerator.

• Filter indicator : The filter Indicator will be Red If you

use water about 300 gallons (6 month) Reset the indi-

cator (it will be Blue) after replacing the filter by holding

the "Ice Type/Water/Hold 3 sec for Filter Reset"

button for 3 seconds.

• Ice off : Press the “Ice Off” button to turn the ice

making function off.

11. Cool Select Pantry (On some models)

• You can select your Pantry temperature from among the following.

Wine Party Dishes (38°F[3°C]) Fresh (38°F[3°C])

Chilled (34°F[1°C]) Deli (41°F[5°C])

12.Food stored in refrigerator is frozen

•If food with too much moisture is stored near the cooling vents, it may get frozen. Be sure to keep moist food away from the cooling vents.

14.Leveling & Door Alignment

•Insert a flat-blade screwdriver into a slot on the control lever, turn it clockwise or counter-clock-

wise to level the door.

Control Lever

Flat-blade screw driver(-)

•Open the freezer drawer to gain an access to the adjustable hinge pin. Next, adjust the refrigerator door using the provided 0.16 inch wrench.

RAISE

•If you need to add more height to the door, insert the provided snap rings.

•For details, refer

to the user manual “Adjusting the level”

DA99-04014A REV(0.3) ENGLISH

DA99-04014A(EN+FR+ES)-0.3.indd 1

2012.4.2 1:55:39 PM