Setting the Clock
For each step, you have a few seconds to set the required optionals. If you exceed this time, you must start again.
1.Switch the system on by pressing the POWER button.
2.Press and hold TIMER/CLOCK button and then press the ENTER button.
Result: "CLOCK" is displayed.
3.Press ENTER.
Result: The hour flashes.
Decrease the hours: ◄
Increase the hours: ►
4.When the correct hour is displayed, press
ENTER.
Result: The minutes flashes.
Decrease the minutes: ◄
Increase the minutes: ►
5.When the correct minute is displayed, press
ENTER.
Result: 
"TIME" appears in the display.
The current time is now set.
✎NOTE
You can display the time, even when you are using another function, by pressing and hold the TIMER/CLOCK button once.
You can also use # or $ on the top panel instead of buttons in step 3,4.
Timer Function
The timer enables you to switch the system on or off at specific times automatically.
Before setting the timer, check that the current time is correct.
For each step, you have a few seconds to set the required optionals. If you exceed this time, you must start again.
If you no longer want the system to be switched on or off automatically, you must cancel the timer.
Example: You wish to wake up to music every morning.
1.Switch the system on by pressing the POWER button.
2.Press and hold the TIMER/CLOCK button and then press ◄ or ► buttons until 
TIME is displayed.
3.Press the ENTER ( 
) button.
Result: ON is displayed for a few seconds,you can set the timer
4.Set the timer switch-on time.
aPress the ◄ or ► button.
bPress the ENTER ( 
) button. Result: The minutes flash.
cPress the ◄ or ► button.
dPress the ENTER ( 
) button.
Result: OFF is displayed for a few seconds, you
can now set the timer
5.Set the timer switch-off time.
aPress the ◄ or ► button.
bPress the ENTER ( 
) button. Result: The minutes flash.
cPress the ◄ or ► button.
dPress the ENTER ( 
) button. Result: VOL XX is displayed, where XX
corresponds to the volume already set.
6.Press ◄ or ► button to adjust the volume level and press the ENTER ( 
) button.
Result: The source to be selected is displayed.
7.Press the ◄ or ► button to select the desired source to be played when the system switches on.
FM (radio) : a Press the ENTER ( 
) button.
bSelect a preset station by press the ◄ or ► button.
DVD/CD (compact disc): Load one compact disc.
USB : Connect the USB device.
✎NOTE
If the auto timer is turned on, the DVD/CD or USB function may require an additional step to be activated depending on the disc (or device). So it is better for you to select the tuner function instead.
04 Basic Functions