Installing the Washing Machine
Connecting the water supply hose (Option)
1.Remove the adaptor |
|
| 4. Connect the water supply hose to the |
from the water |
|
| adaptor. Pull down the part (c) of the water |
supply hose. |
|
| supply hose. When you release part (c) the |
|
| c | hose is automatically connects to the |
|
|
| adaptor making a 'click' sound. |
2.First,using a "+" type screw driver, |
|
| 5. Connect the other end of the water supply |
loosen the four screws on the |
|
| hose to the inlet water valve at the top of |
adaptor. Next,take the adaptor and | a |
| the washer. Screw the hose clockwise all |
turn part(b) following the arrow for | b |
| the way in. |
gap about 5mm between them. |
|
|
|
3. Connect adaptor to the water tap by |
|
| ● If the water tap is a screw type,assemble a |
tightening the screws firmly. | a |
| water supply hose that fits to the tap as |
Then,turn part (b) following the | b |
| shown. |
arrow and put (a) and (b)together. |
|
|
|
NOTICE After completing connection,if water leaks from the hose,then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the water faucet at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move the water faucet, replace the hose with a longer, high pressure hose.
To connect the water supply hose:
1.Connect the cold water supply hose(Blue) fitting with the
2.Connect the other end of the cold water supply hose to your sink’s cold water faucet and tighten it by hand. If necessary, you can reposition the water supply hose at the washing machine end by
loosening the fitting, rotating the hose, and retightening the fitting.
Option :
1.Connect the hot water supply hose(Red) fitting with the
2.Connect the other end of the hot water supply hose to your sink’s hot water faucet and tighten it by hand.
3.If you want to use only cold water, use
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.
90 cm |
60 cm
In a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.
4 SAMSUNG Washing Machine Owner’s Instructions