Connecting the Water Supply Hose Option

CONNECTING THE WATER SUPPLY HOSE (OPTION)

1. Remove the adaptor from the water supply hose.

First, using a ‘+’ type screw driver, loosen the four screws on

the adaptor. Next, take the adaptor and turn part(b) following

the arrow until there is a 5mm gap.

Connect adaptor to the water tap by tightening the screws

firmly.

Then, turn part (b) following the arrow and put(a) and (b)

together.

Connect the water supply hose to the adaptor. Pull down

part (c) of the water supply hose.

When you release part (c) the hose automatically connects

to the adaptor making a ‘click’ sound.

Connect the other end of the water supply hose to the

inlet water valve at the rear of the washer. Screw the hose

clockwise all the way in.

After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

POSITIONING THE DRAIN HOSE

The end of the drain hose may be positioned in three ways:

Over the edge of a sink

The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.

01 Installing the washing machine

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no longer than 90 cm.

Installing the washing machine _9