Installation & Operating Instructions
Please read this entire manual before installation. Save these instructions.
SAFETY NOTICE
<CAUTION: HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS.
<IF THIS HEATER IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT.
<FAILURE TO COMPLY WITH OWNERS' MANUAL INSTRUCTIONS WILL VOID YOUR WARRANTY!
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET FUEL- BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN
INSTALLER: PLEASE LEAVE THIS MANUAL WITH
THE OWNER!!
WARNING: THIS HEATER SHOULD NOT BE INSTALLED IN A SLEEPING ROOM.
Sierra Products, Inc.
5061 Brooks St., Ste. B
Montclair, CA 91763
GENERAL INFORMATION
Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to fuel quality, excessive lint from carpeting, bedding material, etc. It is im perative that control com partm ents, burners and circulat- ing air passageways of the heater be kept clean.
The EASYFIRE Pellet heater has been designed and approved for burning wood pellet fuel only. Burning other form s of fuel is not perm itted and will void all warranties.
This unit has been approved for use with a 4" Type L Pellet Vent System .
NEVER use gasoline,
Ashes must be disposed of in a m etal container with a tight fitting lid and placed on a noncom bustible floor or ground, well away from all fuels, pending final disposal.
NOTE : During the first few burns the high tem perature paint and sealant used in manufacture will emit some odor and sm oke. Open doors and windows to the outside for proper ventilation during the first burn cycle and curing of the paint.
This heater, when installed, m ust be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70-
2006.
Provide adequate clearances around air openings into the com bustion cham ber and adequate accessibility clearance for servicing and proper operation. Never obstruct the front opening of the heater.
The heater may be installed as a
m ay be mounted into an existing U. L. approved wood stove chim ney.
The pellet heater must be operated with a power source and will not operate using natural draft. If there is a power failure the heater will shut down. If the 12 volt back system is in- stalled, the heater will autom atically switch to 12 volt power.
The EasyFire Pellet Heater has been listed by