B9 Accessory holder

Screw both halves together using the screws provided. Slide onto the tube. Fit the accessories onto the holder as shown.

Furniture Brush (1): e.g. for shelves and delicate surfaces.

Upholstery nozzle (2): e.g. for sofas and chairs.

Crevice tool (3): for small gaps like radiators, baseboards, joints and corners.

B10 Air bleed slider

Open the air leak slider on the handle to regulate the airflow or to remove articles that are stuck to the nozzle.

Closed	- high suction power
Open	- low suction power

B11 After vacuum cleaning

Turn the motor off by pressing the button

Remove the plug from the mains supply.

Press the button with your foot or hand to wind up the cable

WARNING: When rewinding always hold the plug.

B12 Transporting

Only use the carrying handle to transport.

B13 Storage

The vacuum cleaner can be stored upright. Turn floor nozzle until the tab on the back of it can be inser- ted into the holder for the tube in the storage position on the bottom of the appliance.

B14 Changing the vacuum cleaner bag

The dust bag must be changed if the suction power is diminished or in case the „Dust bag full“ indicator is on continuously. Also, check whether the vacuum hose, tube or nozzle is blocked.

Press the unlocking button of the dust compartment lid and fold down the dust compartment lid.

B15 Pull the holder with the dust bag rearwards.

Slide the dustbag sideways from the holder.

B16 After removing the full dustbag from the holder, close the inlet.

Dispose of the bag with household waste.

B17 Put a new dust bag into the bag holder.

B18 Replace the bag holder with the dust bag and close the lid.

ATTENTION: Never vacuum without a dust bag.

The lid will not close unless the bag is correctly fitted.

Cleaning the motor protection filter

It is recommended to always clean the filter when the dust bag is changed and to replace it with a new filter after changing the dust bag five times.

UK Helpline 0870 060 2604 Replacement Parts 0870 167 6635 Ireland Helpline 1800 409119