73215 rev3 30/9/08 13:33 Page 5
Hardfloor nozzle
(certain models only)
Attach the hardfloor nozzle ó to either the 2 separate attachable tubes, or the single telescopic tube (dependant on model).
This nozzle is ideal for use on wood, laminate, tile and vinyl flooring.
USE
1Assemble the cleaner as required.
2While holding the cleaner, use the plug to pull out the full length of cable. A red mark indicates the maximum length. Do not try to pull the cable past this mark.
3Connect the plug to the mains supply.
4Press the ON/OFF button Þ.
5Check the suction control and floor nozzle controls are set as required.
6Start vacuuming.
Do not use the cleaner in an upright position.
AFTER USE
1Switch off the vacuum cleaner.
2Unplug from the mains.
3Rewind the cable by pressing the rewind button Ü.
WARNING: When using the cable rewind, always hold the plug, as the cable will rewind quickly.
| EMPTYING THE |
| C |
|
| ||
| DUST CANISTER |
|
|
| WARNING: Never operate |
|
|
| the cleaner without the |
|
|
| dust canister filter |
|
|
| assembly ì or motor |
|
|
| protection filter fitted. |
|
|
1 | Disconnect the cleaner from the |
|
| mains socket. |
|
2 | Disconnect the hose from the | D |
| cleaner. |
|
3 | Remove the dust canister à |
|
| from the cleaner by pushing the |
|
| release latch Ú C. |
|
4 | Take the dust canister to the |
|
| bin. |
|
5 | By using the |
|
| feature ò, rotate the |
|
| pleated filter inside the |
|
| mesh filter to shake loose | E |
| the dust D. | |
6 | Raise the filter assembly ì |
|
| handle then lift out the filter |
|
| assembly from the dust canister |
|
| à E. |
|
7 | Empty the dust canister into the |
|
| bin. |
|
8 | Place the dust canister safely to |
|
| one side. |
|
9 | Clean the filters as described |
|
| overleaf. |
|
10 | Reassemble. |
|
|
|
|
For details of other Morphy Richards products, please see our website: | 5 |