Miele 38ACR installation instructions Tools Required, Bi-Folddoor Installation Steps

Page 2
TOOLS REQUIRED

TOOLS REQUIRED

Phillips screwdriver (small or medium)

Do Not

Loosen (At Least

Touch

Two (2) Turns)

Loosen (At Least

Two (2) Turns)

Remove

And Retain

Note: The pins on the glass end panel require repositioning when the door is fitted into an opposing right or left hand opening. To shift the pins, loosen the pins using a 3/8" open end wrench and slide the pins as required along the frame channel. Position the door squarely within the opening equally gapped at the right and left sides and secure the pins in place by tightening with the wrench.

Outside

BI-FOLD DOOR End Panel

Remove

And Retain

Loosen All Lower Screws (At Least Two (2) Turns)

Figure 2

Remove

Shipping

Corner Post

Top Channel

Screw

(2 Places)

Corner Manual background

Post

Manual background End Panel

Bottom Channel

Figure 6

Step 3. Refer to Figures 2 and 7 and slide the door bottom channel into position. Secure by tightening screws previously loosened through the holes provided on the top face of the chan- nel. Install the door top channel over the middle screw and secure it in place with four screws, two screws previously removed and two screws previously loosened.

2

Step 3. Slide the end panel bottom channel into position and tighten the end screws that were previously loosened. Install the top track over the middle screw and secure with the screws removed and retained in Step 2.

Figure 3

Step 4. Refer to Figures 3 and 4 and install the corner post to the ends of the end panel top and bottom channels. Secure it in place with two screws from the hardware kit.

Step 5. Insert the upper pins of the end panel assembly into the holes in the top channel. Swing the bottom portion of the end panel over the bottom channel and insert the lower pins into the bottom channel.

Figure 4

BI-FOLD DOOR

INSTALLATION STEPS

Step 1. Attach the polished metal and wooden handle assemblies to the lower door frames (Figure 5 ). Use the No. 8-32 x 1/4 Philips pan head screws and associated nuts provided in the hardware kit. There is a single screw and nut for use with each handle assembly. Slide the nuts into the frame channel and insert the screws through the handle brackets and then into the nuts. Position the handle assemblies approximately as shown on the front page of this document and tighten the screws to secure the handles in place.

Figure 5

CAUTION: DO NOT OVER-TIGHTEN HANDLE SCREWS.

Step 2. Install two (2) baffles, one above the other with the black No. 8-15 x 1/2" Phillips pan head screws from the hardware kit (Figure 6 ).

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE

Figure 7

Step 4. Starting with either the right or left door assembly. Engage the hinge pin into the hole in the clip within the top door channel. The roller pin must be positioned within the upper door guide track (Figures 8 and 9 ).

Pivot Pin

Roller Pin

 

Figure 8

Image 2
Contents GENERAL INFORMATION END PANEL INSTALLATION STEPS904665 REV. C 03/2008 INVENTORY LISTBI-FOLDDOOR INSTALLATION STEPS TOOLS REQUIREDCLEANING P/N 904665 REV. C 03/2008 1110 West Taft Avenue Orange, CA