Napco Security Technologies F-64TPBR manual Remove I-FOBs From The System

USER PROGRAM MODE

DELETE I-FOB Y/N

to the system. Create a User I-FOB as follows:

1.Obtain a new I-FOB from your security professional (order part F-IFOB).

2.With “CREATE USER I-FOB Y/N” displayed in the LCD window, press "Y" and the LCD window will request to insert the new I-FOB into the Touchpad.

3.After 5 seconds, the I-FOB will be programmed, and you will be prompted to remove the I-FOB from the Touchpad.

It is recommended that you record the name of each person in possession of each User I-FOB so that you will know which I-FOB user number to delete from the system, as de- scribed in the next section.

Remove I-FOB's From The System

In the event that a User I-FOB is lost, use the following procedure to remove I-FOB's from the system, except the Master I-FOB*:

On a disarmed system:

1.Enter the User Program Mode as described above.

2.Press MENU until “DELETE I-FOB Y/N” displays in the LCD window. Press YES

and "DELETE ENTRY USER I-FOB U02" will appear in the LCD window.

3.Press ENTER and the confirmation message "U02 DELETE ENTRY Y/N" will appear.

4.Press YES and after a short processing interval, the Touchpad will read "U02 DE- LETED DELETE AGAIN Y/N". Press YES to remove another I-FOB user number from the system, or press NO to return to the User Program Mode.

Exit the User Program Mode

•When you have completed programming or erasing User Codes, press RESET to exit the User Program Mode.

*In the event that the Master I-FOB is lost, contact the alarm company to arrange a replacement.

21