Monessen Hearth operating instructions LOG Placement, DFX24C log placement

DFX & DBX Series Vent Free Fireplaces LOG PLACEMENT

Before you begin — This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

	The positioning of the logs is critical to the safe and clean operation of
	this heater. Sooting and other problems may result if the logs are not
WARNING	properly and firmly positioned in the appliance. Never add additional
	logs or embellishments such as pine cones, vermiculite or rock wool
	to the heater. Only use the logs and TPB-RW (rock wool) supplied with
	the unit.
	Failure to position the parts in accordance with diagrams below or
	to use only parts specifically approved for this heater may result in
	property damage or personal injury.
CAUTION	DO NOT sprinkle volcanic rock on the logs or around the pilot or the
	main burner. This may cause sooting. Only place volcanic rock on the
	floor of the fireplace.
	During initial operation of the new heater, burning logs will give off a
	paper burning smell and orange flames will be present. Simply open
	the windows for a few hours to vent the odor.

DFX24C log placement

Figure 19	Left Log
1. Install the rear log (#3) on back of burner.
	#2

2.Install the right log (#1) on burner pins on right side of burner.

3.Install the left log (#2) on burner pins on left side of burner.

Burner

Pins

Figure 19 -

DFX24C Log Placement

Right Log #1

Rear Log #3

Burner

Pins

LG699

18 33D4047