2
TABLE of CONTENTS
PG 3 | INTRODUCTION | 8 | REPLACEMENTS |
| Warranty |
| Replacements |
|
|
| Replacement Parts |
INSTALLATION & FINISHING |
| Accessories | |
|
| ||
| General Instructions |
|
|
| Hood Installation | 9 | SERVICE HISTORY |
Gas Connector Locations
Framing
Nailing Tab Instruction
Mantle Clearances
7OPTIONS
Optional Blower Installation
FOR USE ONLY WITH A ANSI Z21.11.2 LISTED
40,000 BTU/H
FOLLOW THE INSTRUCTIONS, AND
COMPLETE THE INSTALLATION OF THE
UNVENTED ROOM HEATER.
DO NOT BUILD A WOOD FIRE.
Carefully review the instructions supplied with the unvented room heater for the mimimun firebox size requirement.
DO NOT INSTALL AN APPLIANCE IN THIS
FIREBOX UNLESS THIS FIREBOX MEETS THE MINIMUM DIMENSIONS REQUIRED FOR THE INSTALLATION.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
WARNING
•Under no circumstances should this enclosure be modified.
•Provide adequate ventilation and combustion air. Refer to unvented room heaters installation instructions. Never obstruct the front opening of the enclosure.
•Do not burn wood or other materials in this enclosure.
•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Keep young children and animals away when the ventless firebox enclosure is hot.
•Due to high temperatures, the enclosure should be located out of traffic and away from furniture and draperies.
•Clothing or other flammable material should not be placed on or near the enclosure.
•Any safety screen or guard removed for servicing must be replaced prior to operating the enclosure.
•It is imperative that the circulating air passageways in the enclosure are kept clean. The enclosure should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The enclosure area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.
•Furniture or other objects must be kept a minimum of 4 feet away from the front of the ventless firebox enclosure.
•Do not use this enclosure if any part has been under water. Immediately call a qualified service technician to inspect the enclosure and to replace any part of the control system and any gas control which has been under water.
•Do not allow fans to blow directly into the ventless firebox enclosure. Avoid any drafts that alter burner flame patterns.
•Do not use a blower insert, heat exchanger insert or other accessory not approved for use with this enclosure.
NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN