Napoleon Fireplaces Savoy manual General Information, Stove Installation, Principal of Operation

4INTRODUCTION

GENERAL INFORMATION

INSTALLATION

STOVE INSTALLATION

The Savoy is designated as a continuous wood burning heating appliance having a combustion chamber enclosed with cast brick walls where all fuel is meant to be burnt on the grate supplied. It is a top vented appliance capable of being installed near a wall. It has an adjustable air control for controlling the burning rate as well as a large ash-pan.

NOTE: The following items supplied with the unit must be removed from the firebox before attempting to oper- ate the stove: flue collar, door handle tool, poker, oven mitt, ash fender and installation hardware. The stove is not to be connected as a rear vent.

PRINCIPAL OF OPERATION

The Savoy is designed to be operated with the door closed. Without the optional blower, EP62, the heat produced is mainly transmitted through the window and the body of the unit. Combustion occurs on the grate with combustion air introduced through the top of the combustion chamber.

If the stove is to be installed on a combustible floor, it must be placed on an ap- proved non-combustible hearth pad, that extends 8" (200mm) beyond the left stove side and back, and 18" (455mm) to the right stove side and the front.

8"

8" 18"

18"

Be sure to provide sufficient combustion air. There are many other appliances in your home competing for air such as: a kitchen range hood, forced air heating devices or a bath- room exhaust fan.

Expansion / contraction noises during heating up and cool- ing down cycles are normal and to be expected.

After extended periods of non-operation such as following a vacation or a warm weather season, the fireplace may emit a slight odour for a few hours. This is caused by dust particles on the firebox burning off. Open a window to suffi- ciently ventilate the room.

CARE OF GLASS

If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fire will clean the glass. The most common reasons for dirty glass in- clude: not using sufficient fuel to get the stove thoroughly hot, using green or wet wood, closing the air control so far that there is insufficient air for complete combustion. If it is necessary to clean the glass, use a soft cloth with a nonabrasive cleaner. DO NOT CLEAN GLASS WHEN HOT! The glass is very strong but do not let burning fuel rest against it and always close the door gently. If the glass should ever crack while the fire is burning, do not open the door until the fire is out and do not operate the stove again until the glass has been replaced with a new 5mm thick plate of ceramic glass, available from your Napoleon / Wolf Steel Ltd. dealer. DO NOT SUBSTITUTE MATERIALS.

To remove the door glass, open the door; remove the screws and brackets holding the glass in place. Remove all broken glass. Wrap the edges of the new glass with a U-shaped strip of fiberglass gasket, covering 1/4" on each side. Place the glass with the fiberglass gasket in position and replace the brackets and screws. When finished, you should be able to move the glass slightly, horizontally and vertically.

FIGURES 2

Maintain these minimum clearances to combustibles with a single wall chimney connector:

A	20"	(508mm)
B	12"	(304mm)
C	14"	(355mm)
D	28"	(711mm)
E	16"	(406mm)
F	22"	(558mm)

FLUE COLLAR ASSEMBLY

Before the chimney connector can be attached to the stove, the flue collar must be assembled. Remove the top plate by removing the two allen screws on either side of the stove. Fit the ceramic rope into the groove on the top and secure the flue collar with the three bolts and washers supplied. Replace the top plate.

CERAMIC	FLUE COLLAR
ROPE GASKET
TOP PLATE

FIGURE 3 - CUT AWAY SIDE VIEW

W415-0257 / 08.02.01