Installing Fireplace Screen

UNVENTED 32" LogMate® FIREBOX

INSTALLATION

Continued

Figure 13 - Removing Firebox Bottom

Screws

		Heater Base
	to	Mounting
	to	Bracket
	Cut1/4"	Bracket
	Length
	7
		Firebox
		Bottom

1.Insert each rod through nine rings lo- cated at top of screen.

2.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using black shoulder screw.

3.Insert other rod into front hole on right side of firebox and fasten using remain- ing shoulder screw.

	Front	Rear Hole
		Screw
	Hole

Rod

Ring

Screen

floor or using corner mantel, an optional G3005 Slim Base kit may be installed.

1.Assemble cabinet mantel, hearth base, brass trim, and trim accessories. As- sembly instructions are included with each accessory.

2.If using an optional GA3700 blower (FB32CA and NLFB32C models only), install a properly grounded, 120 volt three-prong electrical outlet at firebox location if an outlet is not there. If possible, locate outlet so cabi- net mantel will cover it when installed (see Figure 18).

3.Install gas piping to firebox location. This installation includes an approved flexible gas line (if allowed by local codes) and a manual shutoff valve. The flexible gas line must be the last item installed on the gas piping. See Con- necting to Gas Supply in your log set owner’s manual.

NOTICE: A qualified service per- son must connect firebox to gas supply. Follow all local codes.

Figure 16 - Installing Fireplace Screen

Figure 14 - Cutting Brackets(Shown Without Fireplace Hood for Clarity)

		Gas Line	Electrical
	Flexible	Access	Outlet
Hearth
		Hole
	Gas Line
Base

INSTALLING FIREPLACE HOOD

1.Attach three zinc-colored shoulder screws to back of hood.

2.Insert hood into hood-mounting slots on firebox.

3.Hold hood in place. Insert two black Phillips screws through bottom of hood and tighten.

Hood

Mounting Slot

Shoulder

Screw

Figure 15 - Installing Fireplace Hood

FIREBOX INSTALLATION USING OPTIONAL ACCESSORY MANTELS

This firebox may be installed using the cor- ner or cabinet mantel with hearth base acces- sories against a wall in your home. You must use a GA6090 brass trim kit included with the mantel accessories (see Accessories, pages 12 and 13). Follow the instructions below to install the firebox in this manner.

Note: The instructions below show installa- tion using GM100F/GM101U/GM102W/ GM106F/GM107U series cabinet mantels and the G3000F/G3001U/G3004W/G3006F/ G3007U series hearth base accessories. The hearth base accessory shown is optional for this installation. You can install firebox and cabinet mantel directly on the floor. The corner mantel cannot be installed with the G3000F/G3001U/G3004W/G3006F/ G3007U series hearth base. You must install corner and face mantels directly on the floor. If mounting firebox and cabinet mantel to the

Figure 17 - Placing Hearth Base Accessory Against Wall

Cabinet

Mantel

Figure 18 - Installing Cabinet Mantel

For more information, visit www.desatech.com

105604