Amcor AMH8 owner manual Wall Mounting Installation, Installation Instructions

Wall Mounting Installation

• The heater must be mounted at four
points. Two mounting holes (keyhole		Two Mounting Holes
slots) are located on the upper rear of
the heater and two wall mount angle
brackets are provided for securing the
heater’s bottom to the wall.
• Fit the short edges of the angle brackets
to the heater and secure brackets with
		Approximately 173/4" between
the screws provided, ensuring the long
			the midpoints of the holes
tabs protrude downward (see Fig. 1).
• The heater must be positioned on a wall
away from cold draughts or breezeways
which may interfere with the tempera-
ture control system (rotary thermostat).
• A clearance of at least 6" (152mm) to
BOTH sides of the heater, at least 20	Fig. 1	Two Wall Mount Angle Brackets
inches (508mm) to the front and top of
the heater should be maintained.

•A clearance of at least 8" (205mm) must be maintained above the floor or floor coverings (see Fig. 2).

•	The unit must NOT be positioned	At least 20" (508mm)
	directly under a power outlet.
•	The unit should not be located
	below air extraction vents.

Installation Instructions:

1.Mark the two screw points for the top mounting screws on the wall at dimen- sions shown at right (Fig. 1) 17.75"

(451 mm) apart.

2. Do not Screw Directly into	At least
sheetrock or paneling only.	6"
	(152mm)

3.Screws must be securely screwed into wall studs or by using suitable anchors (not supplied), not completely, leaving 4-5 mm’s (0.16" - 0.2"). Consult a qualified electrican if in doubt.

4. Slide keyhole slots in heater over these	Fig. 2	Install bottom of Heater not less than 8" (205mm)
two screws.		above the finished floor.

5.Connect the two wall mount angle brackets at the bottom of the unit as shown at right (Fig 1).

6.Mark the two screw points (holes in the brackets).

7.Repeat steps 2 & 3 above, only this time screws must be screwed completely.

4