Fujitsu AWU36CX manual To Select Mode Operation Press the START/STOP button L

OPERATION

Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).

To Select Mode Operation

1

2

Press the START/STOP button (Fig. 6 L).

The indoor unit’s OPERATION indicator lamp (green or red) (Fig. 3 5) will light. The air conditioner will start operating.

Press the MASTER CONTROL button (Fig. 6 G) to se- lect the desired mode.

Each time the button is pressed, the mode will change in the following order:

sAUTO	sCOOL	s DRY
*HEATt		FANt

About three seconds later, the entire display will reappear.

Example: When set to COOL

To Set the Thermostat

Press the SET TEMP. buttons (Fig. 6 H).

button: Press to raise the thermostat setting. button: Press to lower the thermostat setting.

●Thermostat setting range:

AUTO 64 to 88 °F

*Heating ............................... 64 to 88 °F Cooling/Dry ........................ 64 to 88 °F

The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the remote control unit’s display).

About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ	Example: When set to 86 °F
somewhat from the actual room temperature.

To Set the Fan Speed

Press the FAN CONTROL button (Fig. 6 K).

Each time the button is pressed, the fan speed changes in the following order:

sAUTO sHIGH sMED sLOW

About three seconds later, the entire display will reappear.

When set to AUTO:

*Heating : Fan operates so as to optimally circulate warmed air.

	However, the fan will operate at very low speed when the temperature
	of the air issued from the indoor unit is low.
Cooling	: As the room temperature approaches that of the thermostat setting,
	the fan speed becomes slower.
Fan	: The fan alternately turns on and off; when on, the fan runs at the low	Example: When set to AUTO
	fan speed.

The fan will operate at a very low setting during Monitor operation and at the start of the Heating mode.

To Stop Operation

Press the START/STOP button.

The OPERATION indicator lamp (green or red) (Fig. 3 5) will go out.

En-6