HAWF2041_09EM1.qxd:HAWF2041_07EM1.qxd 12/19/08 3:59 PM Page 2
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
I N S T R U C T I O N S
When using electrical appliances, basic safety precautions should always be taken including the following:
1. | Read all instructions before using this appliance. |
2. | Use fan only for purposes described in the instruction |
| manual. |
3. | To protect against electrical shock do not immerse |
| unit, plug or cord in water or spray with liquids. Plug |
| the appliance directly into a 120V AC electrical outlet. |
4. | WARNING: To reduce the risk of fire or electrical |
| shock, DO NOT use this fan with any solid-state speed |
| control device. |
5. | Close supervision is necessary when any appliance is |
| used by or near children. |
6. | Unplug from outlet when not in use, when moving |
| fan from one location to another, before putting on |
| or taking off parts and before cleaning. |
7. | Avoid contact with moving parts. |
8. | DO NOT operate in the presence of explosives and/or |
| flammable fumes. |
9. | To avoid fire hazard, NEVER place the cord under |
| rugs or any parts near an open flame, cooking or |
| other heating appliance. |
16.DO NOT operate fan until fully assembled with all parts properly in place.
17.This product is intended for household use only and not for commercial or industrial applications.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS OF THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
The window fan comes fully assembled and is ready for immediate installation.
This window fan has been designed to fit double-hung windows with minimum openings of 25 inches (63 cm) wide and 10 inches (25 cm) high.
Panel (H) until the fan sits safely in your window.
4.If the fan still does not fit snugly attach the Slider Safe® Extender Panel located in the polyfoam packaging in the original box. Align the slot in the Slider Safe® Extender Panel along the tab located on the left side of your Window Fan (G). Slide the Slider Safe® Extender Panel completely down the tab until it is flush on both the top and bottom of the Window Fan.
5.To keep the fan in place, carefully close the window so that the bottom edge of the window rests on the flat area on the top of the fan.
For Slider Windows
1.Set the Fan vertically in your window opening with the left side of the fan situated on the bottom and the Built-In Extender Panel on top.
2.Set the fan into your window opening (note that in most cases the window screen does not have to be removed or left open).
3.If the fan does not fit snugly to the top and bottom of the window casing, attach the Slider Safe®
Extender Panel and adjust the built-in extender screen until the fan fits securely in your window.
OPERATING INSTRUCTIONS
•Make sure rotary switches are in the OFF position.
•Plug into 120V AC electric outlet.
•Set the individual fan motors on either INTAKE, EXHAUST or AIR EXCHANGE using the control level.
•To start the unit, turn the Left/Right Fan Speed Controls to desired speed (HI,MED,LO). Note: If unit will not start, please check that Comfort Control Thermostat is set to HI/largest dot.
•When operating both fans on EXHAUST, set the Comfort Control Thermostat all the way to high by turning the dial CLOCKWISE (to the right) toward the largest dot.
COMFORT CONTROL THERMOSTAT INSTRUCTIONS
Your window fan is equipped with a Comfort Control Thermostat that automatically turns the fan on and off depending on your preset comfort level.
• For the fan to turn on, the thermostat must be set at a temperature higher than the 
current room temperature. If the 
fan power is on but the fan 
blade(s) aren't moving, turn the 
Comfort Control Thermostat dial 
to the right until the fan blade(s)
spin.
• To set your desired comfort level, run the fan until |
the temperature in your room is comfortable. Slowly |
turn the Comfort Control Thermostat dial to the left |
until the fan blades turn off. This is the temperature |
your fan will maintain. |
IMPORTANT: If you desire continuous running of |
the fan, the Comfort Control Thermostat dial should |
be turned all the way to the right to the largest dot. |
• WARNING: BE SURE FAN IS SECURELY INSTALLED IN |
Fan Blade and Front Grill Cleaning
1.Using a phillips head screwdriver, remove the screws that hold the front and rear grills together. Do not completely detach the grills as this may damage the extender clips. Separate only enough to gain access to the blades with one hand.
2.Clean blades and grills with a soft, moist cloth (see above).
3.Securely fasten the grills together.
FAN STORAGE
For all window fans, and fans that come already assembled.
•It is important to keep it in a safe, dry location.
•We recommend using the original (or appropriately sized) box.
•Please remember to protect the fan from dust or moisture.
WINDOW FAN ACCESSORIES
10. | DO NOT operate any appliance with a damaged cord |
| or plug after the appliance malfunctions, or has been |
| dropped/damaged in any manner. |
11. | The use of attachments not recommended or sold by |
| the appliance manufacturer may cause hazards. |
12. | DO NOT use outdoors. |
13. | DO NOT let the cord hang over the edge of a table, |
| counter or come in contact with hot surfaces or leave |
| exposed to high traffic areas. |
14. | To disconnect, grip plug and pull from wall outlet. |
| Never yank on cord. |
15. | Always use on a dry, level surface. |
NOTE: THIS FAN IS DESIGNED AND RECOMMENDED FOR USE WITH A SCREEN IN THE WINDOW.
Window Fan Installation
1.Align the Window Fan horizontally in the window with the controls facing you and the Built-In Extender Panel to the right.
2.Set the fan into your window opening (note that in most cases the window screen does not have to be removed or left open).
3.If the fan does not fit snugly to the left and right of the window casing, pull out the Built-In Extender
FIGURE 1 | G | B | C | D | F |
| | Intake | Exhaust | | | |
| | | Intake | Exhaust | | |
| | | | | |
| H | | | | | |
| | | Off | | | |
| | | High | | | |
| | | Medium | | |
| | | Low | | | |
| A | E | | | | |
YOUR WINDOW AT ALL TIMES. DO NOT LEAN OR |
PUSH ON FAN WHILE IT IS IN THE WINDOW. |
CLEANING/MAINTENANCE
INSTRUCTIONS
Follow these instructions to correctly and safely care for your Holmes window fan.
Please remember:
• | Always unplug the fan before cleaning or |
| disassembling. |
• | Do not allow water to drip on or enter into the fan |
| housing. |
Window Fan | | To order please go to |
| www.holmesproducts.com |
Extender Panel | |
| or call 1-800-546-5637 |
| |
| | |
| | |
| | |
If you have any questions regarding your product or would like to learn more about other Holmes® products, please contact our Consumer Service Department at 1-800-546-5637 or visit our website at www.holmesproducts.com.
