IMPORTANT INSTRUCTIONS
THE HACP9 OSCILLATING CLIP FAN COMES FULLY ASSEMBLED AND IS READY FOR IMMEDIATE USE.
OPERATING INSTRUCTIONS
Step 1: Clip fan onto a dry, level surface
Step 2: Please make sure the On/Speed switch is in the "Off" position. Plug the cord into any standard
Step 3: The SPEED is adjusted by moving the switch left or right to the desired setting.
Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up
WALL MOUNTING INSTRUCTIONS
NOTE: On the underside of the fan’s clip there are “KEY SLOTS” (2).
Select a suitable spot on a wall (away from curtains, draperies, or heat sources) where you want to mount the fan. Use a No. 10 pan head wood screw (1 1/4” length) and thread into a 2x4 wood stud behind the dry wall. Please refer to the warning below if you are unable to locate a wood stud in the wall.
When threading the screw into the wall, leave approximately 1/4” clearance between the screw and wall. This will allow the clip’s “KEY SLOTS” to fit easily and securely over the screws. If necessary, the screw may be tightened further to ensure the fan is firmly attached to the wall.
WARNING: WHEN MOUNTING THE FAN TO PLASTER, DRYWALL OR SHEETROCK, YOU MUST USE A MOLLY BOLT, OR SIMILAR FASTENER. DOING SO WILL PREVENT THE FAN FROM BECOMING DISLODGED WHILE IN OPERATION.
ADJUSTMENT INSTRUCTIONS
Vertical Angle Adjustment
Step 1: To change the tilting angle of the fan head, simply loosen the tilt adjustment knob.
Step 2: Move the fan head to the desired angle, then firmly tighten the knob to lock the fan head in place.
Horizontal Angle Adjustment
Turn the motor housing to the desired direction.
WARNING: MAKE SURE TO SUPPORT THE FAN HEAD ASSEMBLY WHEN LOOSENING THE ADJUSTABLE HEIGHT NUT, AS THE WEIGHT OF THE FAN HEAD MAY CAUSE THE EXTENSION POLE TO COLLAPSE.
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your Holmes oscillating clip fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip on or into the fan motor housing.
•Do not use any of the following as a cleaner: gasoline, thinner, benzine
Step 1: To access the fan blade, remove the front grill by pressing the tabs on the grill ring away from the fan.
Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution.
NOTE: FAN BLADE SHOULD NOT BE REMOVED
Step 3: Replace the front grill by snapping back into rear grill.
Fan Head and Clip Cleaning
Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.
FAN STORAGE
In the off-season:
•IMPORTANT: Keep your fan in a safe dry location, where the fan is not likely to fall or be crushed.
•Your fan should be stored fully assembled.
•Remember to protect the fan head from dust or moisture.