Linear XT-1H warranty Connect Batteries, SET Switches, Test System, Linear Limited Warranty

Page 1

WARNING: THIS

1. PRODUCT DESCRIPTION

2. COMPONENT LOCATIONS

3. INSTALL ANTENNA & BELT CLIP

XT-1H

XT-2H

XT-4H

XTENDED RANGE PORTABLE TRANSMITTERS

For Use With Linear’s

XR Series Xtended

Range Receivers

PRODUCT SHOULD NOT

BE USED IN LIFE

SAFETY APPLICATIONS.

FCC Rules allow

unlicensed high-power transmissions at or near the operating frequency of this product which may interfere with, or even disable, normal operation of this radio device.

Linear’s Xtended Range FM transmitters and receivers are designed for use in various wireless remote control applications. When activated, the XT-H portable transmitters will send a 2 watt, 27.255 MHz, digital encoded, FSK modulated, signal to their companion receiver. The receiver will verify the digital code, activate its output, and trigger the remote device.

These transmitters are available in three models. The Model XT-1H is a one-button, single channel transmitter. The Model XT-4H is a four-button, four channel transmitter. The Model XT-2H is a two-button transmitter with two operating modes. In standard mode, the XT-2H is a three channel device, pressing the left button sends channel one; the right button sends channel two; both buttons send channel three. In lockout mode, the XT-2H will only send a signal (on the channel selected) when both buttons are pressed. Each transmission is limited to a maximum of 30 seconds duration.

The XT-H portable transmitters are powered by two 9-volt alkaline batteries in series, supplying 18 volts. During transmissions, the red operation indicator will light (visible through a window next to the antenna). If the transmitter’s battery voltage is low, the indicator will blink during transmissions. The XT-H transmitters have battery supervision capabilities. If the combined battery voltage drops below 12 volts, a low battery message will be included with any signal transmitted, causing the receiver’s low battery output to activate. The test button next to the indicator sends a test transmission when

SLIDE BATTERY

DOOR DOWN TO

EXPOSE BATTERY

COMPARTMENT

SYSTEM

OPTION

MODE

SWITCH "B"

SWITCH

JUMPER

CONNECT

ANTENNA TO

TRANSMITTER

TWIST TO LOCK

CONNECTOR

IF REQUIRED,

ATTACH THE METAL

BELT CLIP TO THE

REAR OF THE UNIT

WITH THE SCREW

SUPPLIED

Operation

Instructions

XT-4H

(760) 438-7000 • FAX (760) 438-7043

USA & Canada (800) 421-1587 & (800) 392-0123

Toll Free FAX (800) 468-1340

pressed.

Two 8-position switches set the unit’s system code. This code must be matched in the transmitter’s companion receiver. There are 65,536 different system codes possible. The 4-position option switch selects the transmitter’s channel (XT-1H & XT-2H in lockout mode only) and the receiver’s bank (for the XR-16 receiver only).

Each model transmitter is provided with a 6-inch “rubber duck” antenna and a removable belt clip.

SYSTEM

SWITCH "A"

9-VOLT

ALKALINE

BATTERIES

4. CONNECT BATTERIES

CONNECT THE TWO 9-VOLT ALKALINE BATTERIES

TUCK BATTERIES

INTO BATTERY COMPARTMENT

5. SET SWITCHES

 

OPTION

 

SET SYSTEM CODE

 

SYSTEM CODE

SWITCH

 

SWITCHES "A" & "B"

 

 

 

TO MATCH SYSTEM

 

SWITCH "A"

SYSTEM CODE

 

 

 

 

CODE SWITCHES "A" & "B"

 

SWITCH "B"

 

 

 

 

IN THE RECEIVER

 

 

 

 

OPTION SWITCH

 

 

 

 

 

1

2

3

4

 

 

 

 

 

BANK

 

 

CHANNEL

 

 

BANK# 1

2

 

 

3

4

CH#

 

 

1

OFF

OFF

 

 

OFF

OFF

1

SET OPTION SWITCH

2

ON

OFF

 

 

ON

OFF

2

TO SELECT RECEIVER'S

3

OFF

ON

 

 

OFF

ON

3

BANK AND CHANNEL (DON'T

4

ON

ON

 

 

ON

ON

4

SET CHANNEL ON XT-4H OR XT-2H IN STANDARD MODE, THE FRONT BUTTONS CONTROL THE TRANSMITTER'S CHANNEL)

6. TEST SYSTEM

BEFORE TESTING,

REPLACE BATTERY DOOR

MODEL XT-1H

PRESS BUTTON, VERIFY THAT THE PROGRAMMED CHANNEL IN THE RECEIVER ACTIVATES.

MODEL XT-2H

(IN STANDARD MODE)

PRESS LEFT BUTTON, RIGHT BUTTON, THEN BOTH BUTTONS. VERIFY THAT RECEIVER CHANNELS 1, 2 AND 3 ACTIVATE.

LINEAR LIMITED WARRANTY

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of

Linear Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied.

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fill an important need in portable wireless signaling. However, there are some limitations which must be observed.

MODEL XT-2H ONLY

MODE JUMPER CAN BE REMOVED TO SELECT TWO-BUTTON LOCKOUT MODE

MODE JUMPER

NEEDLENOSE

PLIERS

JUMPER ON

"STANDARD" MODE LEFT BUTTON = CH1 RIGHT BUTTON = CH2 BOTH BUTTONS = CH3

JUMPER OFF

"LOCKOUT" MODE

LEFT BUTTON = NO SIGNAL RIGHT BUTTON = NO SIGNAL BOTH BUTTONS = CHANNEL SET ON OPTION SWITCH

APPLY PROPER BUTTON LABEL TO MATCH MODE CHOSEN

MODEL XT-2H

(IN LOCKOUT MODE)

PRESS BOTH TRANSMITTER BUTTONS, VERIFY THAT THE PROGRAMMED CHANNEL IN THE RECEIVER ACTIVATES. PRESS EITHER BUTTON, VERIFY THAT NO SIGNAL IS SENT.

MODEL XT-4H

PRESS EACH TRANSMITTER BUTTON, VERIFY THAT THE CORRECT CHANNEL IN THE RECEIVER ACTIVATES

FOR EACH BUTTON.

WARNING: THIS PRODUCT IS NOT TO BE USED IN LIFE SAFETY APPLICATIONS. FCC Rules allow unlicensed high-power transmissions at or near the operating frequency of this product which may interfere with, or even disable, normal operation of this radio device.

For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 95 Radio Control devices. As such, they have limited transmitter power and therefore limited range.

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.

Changes or modifications to the device may void FCC compliance. Infrequently used radio links should be tested regularly to protect against undetected interference or fault.

A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.

Copyright © 1997 Linear Corporation

215424 A

Page 1 Page 1
Image 1
Page 1 Page 1
Contents Linear Limited Warranty SET SwitchesConnect Batteries Test System

XT-2H, XT-1H, XT-4H specifications

The Linear XT series, including the XT-4H, XT-1H, and XT-2H, represents a significant advancement in personal transportation technology, combining efficiency, versatility, and innovative design. These electric vehicles are engineered for urban mobility, catering to a diverse range of users from commuters to outdoor enthusiasts.

The Linear XT-4H is a versatile model that stands out with its powerful 750W motor and high-capacity battery, providing an impressive range of up to 50 miles on a single charge. Its robust frame is designed for rugged terrains, making it ideal for adventurous riders who traverse diverse landscapes. The XT-4H features an advanced regenerative braking system that not only ensures safety but also prolongs battery life, offering a more sustainable riding experience. Additionally, the intelligent LCD display provides real-time data on speed, distance traveled, and battery status, enhancing user awareness and control.

Moving to the XT-1H, this model targets urban commuters desiring a lightweight yet powerful option for daily travel. The compact design includes a 350W motor, ensuring swift navigation through city streets. With a maximum speed of 20 mph, the XT-1H provides a balance of performance and practicality. It features a foldable frame, making it easy to carry and store, and is equipped with puncture-resistant tires to withstand the challenges of urban environments. Its smart connectivity allows riders to sync with mobile apps for tracking routes and performance analytics.

The XT-2H embodies a blend of performance and comfort. With a 500W motor, it achieves a top speed of 25 mph, catering to both leisurely rides and quick commutes. The ergonomic design includes an adjustable seat, promoting comfort on longer journeys. Signature to the XT-2H is its integrated LED lighting system which enhances visibility and safety during night rides. The vehicle is also equipped with Bluetooth technology, enabling music streaming and hands-free communication, making it a seamless part of riders' lifestyles.

Overall, the Linear XT-4H, XT-1H, and XT-2H showcase a commitment to innovation and user experience. Their distinct features—ranging from ruggedness, portability, and connectivity—underscore Linear’s dedication to redefining personal transport for the modern world. Whether tackling outdoor terrain or urban commuting, these models are engineered to elevate the riding experience.
Top Page Image Contents