Enerco HS35LP manual Specifications, Ventilation, Contents, For Your Safety

SPECIFICATIONS

MODEL NO.	............... 35LP
	35LP
GAS TYPE	LP-Gas
MAX. INLET
PRESSURE	27.5” W.C.
MIN. INLET
PRESSURE	27.5” W.C.
MANIFOLD
PRESSURE	25.5” W.C.

Do not exceed the gas supply pressures shown on rating plate for Model 35LP. The maximum inlet gas supply pressure and the minimum inlet gas supply pressure (for purposes of input adjustment) for LP-Gas are shown as follows:

WARNING

DO NOT EXCEED 27.5” W.C. (1 psi) INLET PRESSURE TO HEATER.

VENTILATION

WARNING

THIS APPLIANCE IS UNVENTED AND MUST BE USED ONLY IN A WELL VENTILATED AREA.

The flow of combustion and ventilation air must not be obstructed. DO NOT use in a tightly enclosed area. Any combustion process requires and consumes oxygen, and may produce carbon monoxide. This heater must be operated with adequate ventilation. Two openings directly to the outdoors must be provided, one low and one high, preferably on opposite sides of the area to be heated. Each of these openings must provide at least three square inches of combustion air-intake area and exhaust outlet area for every 1000 BTUs per hour of heater input rate in order to complete the combustion/ventilation process. Provide additional ventilation for any additional fuel-burning appliances and/or additional occupants.

CLEARANCE (Minimum clearances to combustible materials)

MODEL NO.	BTU/HR RATING		NORMAL OPERATING		CLEARANCES TO
	TYPE GAS		POSTION		COMBUSTIBLES
	NATURAL	LP & NG		TOP	SIDES	BACK	FRONT
35LP		35,000*	VERTICAL	40”	40”	0”	54”

*Tank size and tank temperature can directly affect BTU output

CONTENTS
Installation Instructions	3
Location	3
Piping	3
Operating Instructions	4
Lighting and Shut Down	4
Maintenance Instructions	5
Replacement Parts List	6
Service and Parts Ordering Information	8

FOR YOUR SAFETY

Do not use this heater in a space where gasoline or other liquids having flammable vapors are stored or used.

The heater is designed and approved for use as a construction heater under ANSI Z83.7 / CGA 2.14 - 2000

We cannot anticipate every use which may be made of our heaters. CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.

Other standards govern the use of fuel gases and heat producing products in specific applications. Your local authority can advise you about these.

This appliance is intended to be used primarily for the heating of buildings under construction, alteration or repair.

THE STATE OF CALIFORNIA REQUIRES THE FOLLOWING WARNING:

WARNING

Combustion by-products produced when using this product contain carbon monoxide, a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm).

Enerco Group, Inc. Gas-Fired Infra-Red Portable Construction Heater 2 Operating Instructions and Owner’s Manual