| MPD 32072 |
| hydro flameTM |
9 | |
| Series Furnace |
Technical Installation Manual
ENGLISH, FRANCAIS (et Canada)
THIS INSTRUCTION MANUAL IS FOR USE BY AN AUTHORIZED SERVICE TECHNICIAN TO INSTALL AN ATWOOD - hydro flameTM FURNACE.
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
This furnace design has been certified by the American Gas Association and Canadian Gas Association for installation in recreation vehicles as a MSP Category III furnace. Follow this installation instruction to insure safe operation of the furnace. Failure to install furnace according to this installation instruction nullifies the furnace warranty.
SAFETY ALERT SYMBOLS
Safety Symbols alerting you to potential personal safety hazards. Obey all safety messages following these symbols.
WARNING | CAUTION |
avoid possible | avoid possible |
injury or death | injury and/or property damage |
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
—Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
—WHAT TO DO IF YOU SMELL GAS
•Evacuate all persons from vehicle.
•Shut off gas supply at gas container or source.
•Do not touch any electrical switch, or use any phone or radio in vehicle.
•Do not start vehicle’s engine or electric generator.
•Contact nearest gas supplier or qualified Service Technician for repairs.
•If you cannot reach a gas supplier or qualified Service Technician, contact the nearest fire department.
•Do not turn on gas supply until gas leak(s) has been repaired.
—Installation and service must be performed by a qualified Service Technician, Service Center or gas supplier.
|
| •Installation |
|
| Effective 1/08 |
| INDEX |
|
FURNACE | SPECIFICATIONS | 1 |
| DIMENSIONS | 1 |
| WEIGHT | 1 |
DUCTING CONFIGURATION | 1 | |
MINIMUM CLEARANCE TO FLOORBOARDS, WALLS, |
| |
& SIMILAR COMBUSTIBLE BUILDING MATERIALS | 2 | |
SAFETY INFORMATION | ||
FURNACE INSTALLATION | ||
CUTOUTS | 2 | |
DUCTING | ||
Flexible Ducting | 2 | |
Venting Chart | 3 | |
OPTIONAL INSTALLATION - DIRECTIONAL AIR BOX | 3 | |
PROPANE GAS CONNECTION | 3 | |
ELECTRICAL CONNECTIONS | 3 | |
Thermostat Installation | 3 | |
Door Installation | 3 | |
SYSTEM CHECK TESTS | 4 | |
PROPANE GAS PRESSURE | 4 | |
FIGURES | 4 | |
REPLACEMENT PARTS LIST & DRAWING | 8 | |
DUCTING CONFIGURATIONS |
| |
| ONE | BOTH |
FRONT | side duct | side ducts |
79/80 SERIES | 79 SERIES | 79 SERIES |
80SERIES (
SPECIFICATIONS |
|
|
|
|
|
|
|
|
| (W.C. = Water Column) | |||
MODEL # |
|
|
|
|
|
|
|
|
| ||||
Input BTU/HR | 12,000 |
|
|
| 16,000 |
| 18,000 |
| 12,000 | ||||
Output Capacity BTU/HR | 9,160 |
|
|
| 12,160 |
| 13,680 |
| 9,120 | ||||
Duct Static Pressure - | .20" W.C. |
| .10" W.C. |
| .10" W.C. |
| N/A | ||||||
12 Volt Amperage (AMPS) | 3.4 |
|
|
| 3.4 |
| 3.4 |
| 1.8 | ||||
Watts | 40.8 |
|
|
| 40.8 |
| 40.8 |
| 21.6 | ||||
Power Supply (Volt DC) | 12 |
|
|
|
| 12 |
| 12 |
| 12 | |||
MINIMUM RETURN AIR | 35 in2 |
|
|
| 35 in2 |
|
| 35 in2 |
| 35 in2 | |||
DIMENSIONS |
|
|
|
|
|
|
|
|
| WEIGHT | |||
ALL MODEL |
| WIDTH |
| HEIGHT |
| DEPTH |
| ||||||
Casing |
|
|
|
| FURNACE | 23 lbs | |||||||
Door |
|
|
|
| SHIPPING | 25 lbs | |||||||
MINIMUM CLEARANCE TO |
| ||||||||||||
FLOORBOARDS, WALLS & SIMILAR COMBUSTIBLE BUILDING MATERIALS | |||||||||||||
|
|
|
|
|
|
|
|
|
| ||||
MUST BE PROVIDED THE FULL LENGTH AND WIDTH OF UNIT |
| ||||||||||||
Top and Sides | 0˝ |
| TO CASING SPACERS (SCREW HEADS) |
| |||||||||
Extension Box | 0˝ |
|
|
|
|
|
|
|
|
|
| ||
Rear | 0˝ |
|
|
|
|
|
|
|
|
|
| ||
Bottom | 0˝ |
| TO CASING SPACERS (SCREW HEADS) |
| |||||||||
1