Broan 30042432A warranty Installation and Operating Instructions, Unit Certification

INSTALLATION AND OPERATING INSTRUCTIONS

This furnace has been designed and manufactured to give the most reliable performance possible. Each unit has been given a running inspection before shipment to assure that every component is operating efficiently.

	TOP VIEW
	1½”
	(38 mm)
	17” x 17”
20”	(432mmx432mm)		1½”
	DISCHARGE
(508 mm)		(38 mm)

The safe and dependable operation of the furnace depends upon proper installation and compliance with all national and local codes and standards.

WIRING KO’S VALUES

A = 1” (25 mm)

B = 1/4” (6 mm) & 1¼” (32 mm)

C = 1/2” (13 mm) & 1½” (38 mm)

FRONT VIEW RIGHT SIDE VIEW REAR VIEW

	20”		1”
(508 mm)		(25 mm)

LEFT SIDE VIEW

39”

(991 mm)

FILTER FRAME (EITHER SIDE, REAR OR BOTTOM)

1½” x 1½” KO

(38 mm x 38 mm)

WIRING KO’S

A

B

C

18” x 18”

(457mmx457mm)

RETURN

1½” x 1½” KO

(38 mm x 38 mm)

18” x 18”

(457mmx457mm)

RETURN

1½” x 1½” KO

(38 mm x 38 mm)

WIRING KO’S

C

18” x 18”

(457mmx457mm)

RETURN

UNIT CERTIFICATION

This furnace is CSA certified. ®

GENERAL REQUIREMENTS AND SPECIFICATIONS

CAUTION

This unit must be installed in a dry place, in a non-corrosive, well-ventilated environment, without excessive dust. The ambient temperature must be over 10°C and under 27°C. If the ambient temperature is 10°C or less, the plenum must be insulated on 10 ft linear minimum length.

1.LOCATION – The furnace should be centrally located to the heating area.

2.POSITIONS – It can be installed for vertical, horizontal or downflow operation. When installed horizontally, the furnace should be positioned such as the door will not end up being on the top. The door should be on the side of the furnace, to ensure that the motor bearings are in their designed position. In vertical downflow installations, use only “L”- or “T”-shaped plenum with no openings or registers directly below furnace.

3.INSTALLATION CLEARANCES – As shipped from the factory, each unit is approved for “zero inch” clearance. If additional clearance is required, it will be indicated on the data label attached to the furnace.

4.TEMPERATURE RISE – Furnaces are shipped to operate at 0.20” W.C. (50 Pa) external static pressure. They are certified for operation up to 0.50” W.C. (125 Pa). Check the following page for temperature rise table on specification chart and, if necessary, adjust the unit to match.

5.SERVICE CLEARANCE – Units are serviced from the FRONT. Leave at least 24” (610 mm) clearance in front of the door.

2