WIRING DIAGRAM:
Master
A1
A2
Output to Host
Access Control System
1A1
1A2
2A1
2A2
S
S
B1
B2
+ |
- |
+ |
- |
TESTING AND OPERATION:
When power is applied to the iClass reader, the LED will turn RED while the beeper beeps simultaneously 3 times. (The last tone is a higher frequency). The LED will then flash once after the last tone. This indicates that the microcontroller is operating properly.
Present an iClass ID card to the reader (Hold the card directly in front of reader). The LED will momentarily turn green while the beeper beeps once, indicating that the card was read successfully.
SPECIFICATIONS:
CARD READER: |
| CAMERA: |
|
Power Source: | 10 ~ 16 VDC / 65 ~ 225mA | Camera unit: | CCD Camera |
Current Requirements: | 80mA (Avg); 300mA (peak) at 12V | Scanning line: | 525 lines |
Transmit Frequency: | 13.56 MHz | Min. illumination: | 1 Lux or less at 1' |
Terminations: | Terminations: | Screw terminals | |
Wiring Distance: | 500' | Wiring Distance: | 330' w/871802 wire |
Operating Temperature: |
| 980' | |
Operating Humidity: | 5% to 95% relative humidity | Dimensions (camera): | |
| With | ||
|
|
| |
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference that may cause undesired operation. For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a previously certified power supply.
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005 | TOLL FREE TECHNICAL SUPPORT: (800) | Page 2 |
(425) | TOLL FREE FAX LINE: (800) | |
FAX (425) | 0706JDJS |