Audiovox APS-786 owner manual Protection While the System is Armed, Disarming the System

Page 3

1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.

The dash mounted LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point is opened during the 30 second arming cycle, arming will be suspended. When all entry points are closed, the arming cycle will begin again.

At the end of the 30 seconds, the parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming the system is armed. If the siren did not sound when arming, then the chirps have been turned off. Refer to the section on "Eliminating the Arm/Disarm Chirps" shown later in this manual. Passive door locking is a selectable feature. If you have the optional door lock/unlock circuit installed, the doors may or may not lock passively depending upon the setup during installation.

PROTECTION WHILE THE SYSTEM IS ARMED:

Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger immediately. The siren will sound and the parking lights will flash for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left the door opened, the unit will sound for six 30 second cycles then shut down, isolate the triggered zone and continue to protect all other zones.

Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a visual deterrent to a potential thief. This LED is a very low current light emitting diode, and will not cause the battery to drain even if left unattended for long periods of time.

Whenever the system is triggered, the vehicle's parking lights will flash for the full siren sounding period. Optional - whenever the system is triggered, the interior courtesy light will flash for the full siren sounding period.

Whenever the system is armed, the vehicle starter circuit is disabled, and the vehicle will not start with the ignition key.

Whenever the system is armed, any strong impact to the vehicle will cause the shock detector to trigger the alarm. Any lesser impact will cause the pre-detect stage of the shock sensor to emit a few short series of warning tones from the siren.

DISARMING THE SYSTEM

As you approach the vehicle, press and release the Disarm button on the keychain transmitter. The parking lights will flash two times, the siren will chirp twice, and the dash mounted LED will turn off.

If you have the optional door lock/unlock circuit installed, the doors will unlock. If you have the optional entry illumination circuit installed, the interior light will turn on for 30 seconds or until the ignition key is switched on.

NOTE: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming. Opening any door will suspend the automatic arming.

If the parking lights flashed three times, and the siren chirps four times, this indicates that the alarm system was triggered during your absence. Before turning on the ignition key, examine the dash mounted LED's flash pattern. The number of flashes identifies the trig- gered zone. For additional information, refer to INTRUSION WARNING SIGNALS found later in this manual.

If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the section titled ELIMINATING THE ARM/DISARM CHIRPS.

NOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing the unlock button a

Page 3

128-6530

3 of 10

Image 3
Contents Model APS-786 Arming the System Passive Automatic Your Code Hopping TransmittersArming the System Active Silent Arming ActiveDisarming the System Protection While the System is ArmedWhile the System is Sounding Intrusion Warning SignalValet Switch Silent DisarmingProgramming Your Custom Override Code Eliminating the Normal ARM/DISARM Chirps Custom Code Programming ExampleRemote Starting the Vehicle Remote Panic OperationAdditional Remote Function Channel Operating on Automatic Start UP Timer ModeTo Begin the Automatic Start UP Timer Canceling the Automatic Start UP Timer128-6530 System Functions AT a Glance

APS-786 specifications

The Audiovox APS-786 is a state-of-the-art car alarm and remote start system designed to provide unparalleled security and convenience for car owners. This comprehensive system stands out in the market due to its impressive array of features, innovative technologies, and user-friendly characteristics.

One of the key highlights of the APS-786 is its advanced two-way communication capability. This feature enables the owner to receive real-time status updates on their vehicle, including notifications of unauthorized entry attempts. The inclusion of a vibrant LCD remote not only enhances communication but also allows users to interact with their vehicle from a distance, providing peace of mind and increased security.

In terms of security, the APS-786 is equipped with a high-powered siren that is capable of delivering attention-grabbing alerts in the event of a breach. The system uses a combination of shock sensors, door triggers, and hood/ trunk protection to detect any suspicious activities. For added safeguarding, the APS-786 includes features such as a starter disable function and a built-in anti-grind relay to thwart potential theft attempts.

Another notable feature of the Audiovox APS-786 is its integration of remote start functionality, which allows users to start their vehicles from a considerable distance. This is particularly advantageous in extreme weather conditions, as it allows the vehicle's interior to reach a comfortable temperature before the driver even enters.

The system's installation flexibility is also a significant advantage. It is designed to fit a wide range of vehicles, making it a versatile choice for various automotive applications. Additionally, the APS-786 supports keyless entry, allowing users to unlock their doors conveniently without fumbling for keys.

Furthermore, the APS-786 employs frequency-hopping spread spectrum technology, which enhances the communication range and reduces the likelihood of signal interference. This technology, combined with extended range capabilities, ensures that users can monitor and control their vehicle effectively, even in challenging environments.

In summary, the Audiovox APS-786 is a versatile and powerful car alarm and remote start system that combines advanced security features with user-friendly options. Its combination of two-way communication, shock sensors, remote start capabilities, and modern technological advancements makes it a compelling choice for anyone looking to enhance their vehicle's security and convenience.