Magnadyne ALA200FKE Automatic Arming with Manual Disarming, What to do if the Alarm is Sounding

System Control by the Factory Supplied Keyless Entry Transmitter (Basic Operation) (cont.)

*Some factory keyless entry systems have chirp confirmation as a built in feature. If this is true for your vehicle, when the doors are locked or unlocked with the factory keyless transmitter, you may get more than 1 or 2 chirps as indicated above. If this condition becomes undesirable, the chirp indication from the ALA200FKE can be turned off allowing only the factory system chirp. Contact your dealer for more details.

Automatic Arming with Manual Disarming

Note: When you take delivery of your new vehicle and Silencer ALA200FKE security system, the automatic arming feature is active to protect your vehicle even if you forget to arm your security system. If the feature becomes undesirable, it can be programmed off leaving manual arming your only method to secure your vehicle. Contact your dealer for further information.

1.Exit the vehicle and close all protected entrances. Once the last protected entrance is closed, your Silencer security system will respond in the following manner:

A.The vehicle horn will beep one time.

B.The LED indicator will begin to flash fast to indicate that the 30 second automatic arming timer is counting down.

2.After 30 seconds has passed**, your Silencer security system will respond as follows:

A.The vehicle horn will beep once again indicating that the security system is fully armed.

B.The parking lights may flash one time. (Parking light flash option required)

C.The LED indicator will resume a normal flash speed indicating an armed condition.

D.The doors will become locked. (See Note 1)

Note 1: Auto arm door lock control is an optional feature described in the back of this manual.

**The dome lights in some vehicles have a delay before they turn completely off. If your vehicle has this type of delay, the 30 second automatic arming timer will start when the dome light is completely off. Depending on the length of time it takes the dome light to turn off, automatic arming may take 45 to 60 seconds or more.

What to do if the Alarm is Sounding

Press the UNLOCK button on your keyless entry transmitter. A. The vehicle horn will stop beeping.

B. The parking lights may stop flashing. (Parking light flash option required)

C. The LED indicator will begin a special tamper mode flash sequence to let you know that your security system had been triggered.

Notations on Basic Operating Procedures

1.When you disarm the system while it is sounding, there are no disarm chirps.

2.After the security system has been triggered, the LED remains flashing even thought the security system has been disarmed. This is a tamper indicator. Turning on the ignition key will reset this indicator.

System Control by the Silencer Remote Transmitter (Basic Operation)

If you purchased the ALA200FKE Silencer security system and your vehicle did not come with a factory keyless system, your dealer would have supplied you with 2 Silencer remote transmitters. Use the lock and unlock buttons on the transmitter to control your security system in the following manner:

Manual Arming and Disarming

1.Exit the vehicle and close all of the entrances.

Note: After closing the last protected entrance, you will hear the siren or horn chirp. The reason for this chirp is covered in the “Automatic Arming” section of the manual. Proceed as follows:

3