Section 5 - Trouble Shooting Guide
Problem | Possible Causes | Solutions |
|
|
|
|
|
No audio and no display on the | Receiver is off | Make sure that the power supply is |
|
receiver |
| properly connected and the on/off but- |
|
|
| ton is in the on position |
|
|
|
|
|
No audio and no RF signal indicator | Transmitter is off | Turn on transmitter power switch |
|
on the receiver display |
|
|
|
Transmitter is on a different channel | Match the transmitter group and chan- |
| |
|
| ||
|
| nel to the one displayed on the receiver. |
|
|
|
|
|
| No (or dead) battery in transmitter | Insert fresh battery in transmitter |
|
|
|
|
|
| Faulty battery contacts | Clean and or bend contact |
|
|
|
|
|
No Audio with good RF signal indica- | Microphone not connected | Check the TA4F connector on the |
|
tor but no (or low) Audio indicator on |
| bodypack or the detachable micro- |
|
the receiver display |
| phone element connection on the |
|
|
| handheld |
|
|
|
|
|
| Low gain setting on the transmitter | Increase the transmitter gain |
|
|
|
|
|
No (or low) Audio with good RF sig- | Receiver audio output cable is dam- | Connect, repair or replace cable |
|
nal and Audio indicators on receiver | aged or disconnected |
|
|
display |
|
|
|
Gain not sufficient on | Increase gain on mixer or |
| |
|
| ||
| mixer/preamp/amp input or it is muted | the input |
|
|
|
|
|
| Receiver output too low (1/4" output) | Increase the audio output setting |
|
|
|
|
|
Distorted audio signal | Transmitter audio gain too high | Decrease the transmitter gain setting |
|
|
|
|
|
| Receiver output too high (1/4" output) | Decrease the receiver output setting |
|
|
|
|
|
| Battery level low in transmitter | Insert fresh battery in transmitter |
|
|
|
|
|
| Another | Make sure all the channels in use are |
|
Interference | tion is on the same channel or the sig- | from the same group. Use ClearScanTM |
|
| nals are mixing | to select the clearest group. If more |
|
|
| channels are needed call Telex at |
|
|
|
| |
|
|
|
|
| Another wireless product in the area is | Use ClearScanTM to change the operat- |
|
| on the same frequency or the signals | ing frequency. If problems persist, call |
|
| are mixing | Telex at |
|
|
| help |
|
|
|
|
|