Universal Security Instruments SS-795 specification

RECOMMENDED LOCATION OF ALARMS

•Locate the first smoke alarm in the immediate area of the bedrooms. Try to protect the escape route as the bedrooms are usually farthest from an exit. If more than one sleeping area exists, locate additional smoke alarms in each sleeping area. If a hall is more than 40 feet (12 meters) long, install a smoke alarm at each end.

•Locate additional smoke alarms to protect any stairway as stairways act like chimneys for smoke and heat.

•Locate at least one smoke alarm on every floor level.

•Locate a smoke alarm in any area where a smoker sleeps or where electrical appliances are operated in sleeping areas.

•Smoke, heat and other combustion products rise to the ceiling and spread horizontally. Mounting the smoke alarm on the ceiling in the center of the room places it closest to all points in the room. Ceiling mounting is preferred in ordinary residential construction. However, in mobile homes, wall mounting on an inside partition is preferred to avoid the thermal barrier that may form at the ceiling.

•When mounting smoke alarm on the ceiling, locate it a minimum of 4" (10cm) from a side wall or corner (see Diagram A).

•When mounting smoke alarm on a wall, if local codes allow, use an inside wall with the top edge of the smoke alarm a minimum of 4" (10cm) and a maximum of 12" (30.5cm) below the ceiling/ wall intersections (See Diagram A).

Existing Homes:

The NFPA requires a smoke alarm on every level and outside each sleeping area in existing construction. An existing household with one level and one sleeping area is required to have one smoke alarm.

New Construction Homes and Manufactured Homes:

The NFPArequires AC-powered, interconnected smoke alarms to be installed inside each bedroom, outside each bedroom area, and on every level of the home. They also require a minimum of two AC-powered, interconnected smoke alarms in any new construction home.

Sloped Ceilings (Peaked Ceilings):

Smoke alarms or smoke detectors mounted on a peaked ceiling shall be located within 36 in. (914 mm) horizontally of the peak, but not closer than 4 in. (102 mm) vertically to the peak.

Sloped Ceilings (Shed Ceilings):

Smoke alarms or smoke detectors mounted on a sloped ceiling having a rise greater than 1 ft. in 8 ft. (1 m in 8

m)horizontally shall be located within 36 in. (914 mm) of the high side of the ceiling, but not closer than 4 in. (102

mm)from the adjoining wall surface.

Tray-Shaped Ceilings:

Smoke Alarms or smoke detectors shall be installed on the highest portion of the ceiling or on the sloped portion of the ceiling within 12 in. (305 mm) vertically down from the highest point.

Mobile Home Installation:

For minimum protection, smoke alarms should be installed in compliance with H.U.D. Manufactured Home Construction Safety Standards, Title 24 CFR, Section 3280.208 and Section 3282. For additional protection, see Single Story Residence smoke alarm requirements/recommendations for Existing Homes and New Construction Homes.

Note: For mobile homes built before 1978, install smoke alarms on inside walls between 4” and 12” from the ceiling (older mobile homes have little or no insulation in the ceiling). This is especially important if the ceiling is unusually hot or cold.

Install a smoke alarm inside each bedroom and in the hallway outside each separate sleeping area.

Page 2

SS-795 specifications

Universal Security Instruments SS-795 is a state-of-the-art smoke and carbon monoxide detector designed to enhance safety in residential and commercial settings. Built with advanced technology and user-friendly features, this device offers comprehensive protection from potential fire and carbon monoxide hazards.

One of the standout features of the SS-795 is its dual-sensor technology, which combines photoelectric and ionic sensors. This dual approach allows the device to detect smoke from various types of fires, including both smoldering and fast-flaming fires, ensuring a quicker reaction to potential dangers. The photoelectric sensor is particularly efficient in detecting slow-burning fires, which often produce more smoke and are more likely to occur in residential environments.

Another key characteristic of the SS-795 is its built-in voice alarm system. This feature includes a clear voice announcement that not only alerts users to the presence of smoke or carbon monoxide but also specifies the nature of the hazard. This is particularly beneficial for households with children or elderly members, as it ensures that everyone is promptly informed of the danger.

The SS-795 is also equipped with a unique hush feature, allowing users to temporarily silence the alarm during false alarms, such as those caused by cooking smoke. This prevents unnecessary panic and ensures that the alarm only sounds when genuinely needed. In addition, the detector comes with a low battery chirp indicator, notifying users when it’s time to replace the battery for optimal performance.

Installation is straightforward, thanks to the user-friendly design of the SS-795. The device is battery-powered, ensuring that it remains operational even during power outages. Its sleek design allows for easy integration into any home decor, whether mounted on a ceiling or placed on a wall.

In conclusion, Universal Security Instruments SS-795 is a reliable and multifunctional smoke and carbon monoxide detector that prioritizes safety. With its advanced dual-sensor technology, voice alarm system, hush feature, and easy installation, it effectively addresses the needs of modern users. Investing in the SS-795 is a proactive step towards protecting your home and loved ones from potential fire-related hazards.