Klipsch P-39F owner manual Getting Started Preparing the Loudspeaker, Unpacking

Page 3

Getting Started

Preparing the Loudspeaker

Unpacking

Please follow the unpacking instructions fully and in the order shown below. These loudspeakers are heavy! Do not lift or move these speakers by yourself. Always have someone help you.

1

Open the carton flaps

2

Remove the Grille box

 

Lightly tape each flap to the box

 

Remove the Accessories box

 

with short pieces of tape

 

Remove the Owner’s manual

 

Remove the top packing piece

 

and gloves

3

Carefully invert the carton

4

 

Lift off the carton

 

 

Connection Procedure:

There is a specific procedure to be followed:

•Switch off and unplug the amplifier/s and all source electronics from the mains power.

•Place both loudspeakers in the general area where you want them.

•Place each loudspeaker on its side, in its partial packing, as described in the unpacking instructions.

•Connect each loudspeaker.

•Attach the spikes following the instructions under the “finalizing the assembly” section of this manual.

•Position the loudspeaker cable between the rear spikes.

•Stand the loudspeaker upright, using great care not to damage connecting cables, furniture or the floor.

•Lift off the top packing piece and the protective cloth bag.

•Run both sets of loudspeaker cables to the amplifier.

•Connect the amplifier.

•Finalize the position of the loudspeakers.

•Finally, fit the grilles (if desired).

TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND. TO PRESERVE THE FINISH, USE THE PROVIDED GLOVES WHEN HANDLING YOUR LOUDSPEAKERS.

Fitting and Removing the Grilles

5

Lift off the center and base packing pieces

The loudspeaker is ready for connection

The grilles are magnetically attached to the cabinet. Specially designed magnets are housed inside the front wall of the loudspeaker, so that if you wish to operate the loudspeaker with the grilles removed, no grille mounting hardware is visible. This preserves the smooth lines of the loudspeaker.

To fit the grilles: Fit the top grille first and line it up with the top and sides of the cabinet. There is a small lip on the top of the grille that should rest on the top of the cabinet. Now, fit the lower grille, lining up the top of the lower grille with the bottom of the upper grille. You may now remove the top grille if you wish.

Page 4

What’s in the box?

•The grille box contains: one upper grille; one lower grille.

•The Accessories box contains: four long spikes; four short spikes; four spike seats; two bi-wiring

straps: one Allen wrench.

•There is a pair of gloves located in a pocket in the side of the packing carton beside the Owner’s manual.

Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch dealer and the transport contractor for action.

Although operating the P-39F loudspeakers with the grilles on or off is a matter of personal taste, moving or connecting the loudspeakers should always be done with the grilles removed. Be especially careful not to touch the drive units.

Page 5

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Palladium P-39F General Cautions Important Safety Instructions IntroductionUnpacking Getting Started Preparing the LoudspeakerGeneral Observations Stereo PositioningConnecting a Terminal Standard Single WiringP 39-F Terminal Panel To multi-amp, the following criteria are essential Bi-wiringTri-wiring Bi-amping and Tri-ampingStanding the Loudspeakers Upright Finalizing the Assembly Final AdjustmentsFitting Spikes Dressing the CablesBass Drivers About Your Loudspeaker Loudspeaker ComponentsAn International Project DesignTractrix Horn Design Treble Compression DriverCrossover Network CabinetLong, Long, Road Conclusion Care and MaintenanceWarranty Warranty Outside The United States and Canada

P-39F specifications

The Klipsch P-39F is a remarkable floorstanding speaker that epitomizes the brand's commitment to delivering high-quality audio experiences. Renowned for its dynamic sound performance and sleek aesthetics, this speaker is tailored to meet the demands of audiophiles and casual listeners alike.

At the heart of the P-39F is its innovative three-way design, which includes a 12-inch woofers, a 5-inch midrange driver, and a 1-inch titanium compression driver. This configuration allows for a full-frequency response, reproducing deep bass, detailed mids, and crisp highs. The inclusion of the Tractrix horn technology enhances the speaker’s efficiency by directing high frequencies with precision, leading to a more immersive soundstage that draws listeners into the heart of their favorite music or movies.

One of the standout features of the P-39F is its exceptional sensitivity rating of 98 dB. This means the speaker can produce high volumes even with lower-powered amplifiers, making it a versatile choice for diverse audio setups. The carefully engineered cabinet is crafted from high-quality wood materials and finished with elegant veneers, offering both aesthetic appeal and acoustic performance. The reinforced construction minimizes unwanted resonance, ensuring that the sound remains pure and undistorted across all volume levels.

The P-39F also employs Klipsch's proprietary Linear Travel Suspension (LTS) technology, which reduces distortion and enhances overall clarity. This technology works seamlessly with the speaker's large cone area to provide dynamic range and nuanced detail that truly brings recordings to life.

Additionally, the P-39F features bi-wiring or bi-amping capabilities, allowing audio enthusiasts to connect multiple amplifiers or wires to enhance the speaker's performance further. This flexibility is appreciated by those seeking to customize their listening experiences.

In terms of aesthetics, the Klipsch P-39F is available in multiple finishes, ensuring it can complement any home décor. Its elegant design, combined with its high-performance capabilities, makes it a showpiece in any room while providing an unparalleled audio experience.

In conclusion, the Klipsch P-39F is a pinnacle of audio engineering, combining advanced technologies and thoughtful design to deliver an outstanding sound experience. Whether for music or home theater, this speaker is sure to impress with its blend of beauty, power, and precision.
Top Page Image Contents