Linear DXT-72 installation instructions Product Description Remove Mounting Plate

DXT-72		PRODUCT DESCRIPTION		REMOVE MOUNTING PLATE
		The DXT-72 is a photoelectric smoke alarm with a built-in
		transmitter designed for use with Linear’s DX Format receivers.		TWIST MOUNTING
		When smoke is detected, the alarm sounds a loud local
				PLATE TO
		alarm. Twenty seconds after the local alarm sounds, the built-			REMOVE
	BY			UNLOCK
		in transmitter sends a digitally coded wireless signal to its
					MOUNTING
WIRELESS		companion receiver. The wireless signal will be repeated every
					PLATE
		20 seconds as long as smoke is still present.
PHOTOELECTRIC		The digital DX code format features over a million possible
SMOKE		codes. The DX transmitters are precoded at the factory to unique
		codes, so no fi eld coding is required. The DXT-72 can send three
ALARM		different codes: alarm, test and low battery.
		For versatility, any transmitter can be programmed into any
		receiver channel. Receivers must be programmed to the
Installation		transmitter’s code before system testing and operation. Refer to
		the receiver’s instructions for details on programming.
Instructions		The unit is powered by two 9-volt alkaline or lithium batteries.
		These batteries are supplied with the transmitter and can power
		the unit for up to two years. If the battery voltage drops below
		a preset level the alarm will sound low battery beeps and a
		low battery signal will be sent to the receiver every hour (some
		receivers can report low battery, others cannot).
(760) 438-7000		☞ NOTE: After replacing batteries, press transmitter	test
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340		button to reset “low battery circuit”.
www.linearcorp.com
DXT-72 FEATURES		INSTALL BATTERIES		CHOOSE ALARM LOCATION
		PRESS TRANSMITTER TEST BUTTON
		AFTER INSTALLING BATTERIES
	TRANSMIT LED	TO PRE-SET LOW BATTERY CIRCUIT
TRANSMITTER	TRANSMITTER
	TEST BUTTON
BOARD

	CONNECT AND INSTALL
BATTERY	TWO 9-VOLT DURACELL
HOLDING	ALKALINE MN1604 OR
CUPS	ULTRALIFE LITHIUM U9VL
	BATTERIES
INSTALL MOUNTING PLATE	PROGRAM RECEIVER	MOUNT ALARM ON PLATE
SCREW	REFER TO RECEIVER'S INSTRUCTIONS	MATCH UP
		ALIGNMENT
	TO PREPARE RECEIVER TO ACCEPT THE
ANCHORS		TABS
FOR WALLBOARD	TRANSMITTER'S CODE

PRESS TRANSMITTER

TEST BUTTON

TO SEND SIGNAL

OR

PLASTIC SINGLE-GANG ELECTRICAL BOX

TWIST SMOKE ALARM CLOCKWISE TO LOCK TO MOUNTING PLATE