Klipsch IC - SW - 8 T 2 owner manual IC SW 8T2 Round, Contents Description

I C - S W - 8 T 2

Thank you for purchasing your

Klipsch IC-SW-8T2 in-ceiling subwoofer.

The IC-SW-8T2 in-ceiling speaker is designed for music reinforce- ment applications. Unobtrusive, these loudspeakers are engi- neered for easy, versatile installation.

The IC-SW-8T2 features a transformer-less design for 70.7V/100V distributed-line systems. Some of the benefits of this design are: Elimintation of transformer saturation at high output levels, elimination of transformer insertion losses, improved bandwidth (particularly at low frequencies), and improves power transfer to the loudspeaker at low frequencies. For applications where 4 ohm mono or 8 ohm stereo operation is required, the mode of operation can be selected by using an optional connection located on the back input terminal and by properly setting the rotary switch located under the grill.

Before installing your speakers take a moment to check the contents of the cartons and make sure nothing has been damaged in transit.

3.To install the tilebridge, fold the rail side of the ring back upon itself using the spring tensioner on the reinforcement ring to allow insertion into the cutout hole. Once it is inserted into the cutout hole, release the reinforcement ring such that it unfolds back to its normal position. Position tilebridge over cutout hole.

Contents Description

Speaker Module

Grille

Reinforcement Ring

Rails

Cardboard Cutout Template and Paint Mask Screws (Attach Rails to Reinforcement Ring) 3/8" Adapter Fittings

1/2" Adapter Fittings

QUANTIT Y

1

1

1

2

1

2

1

1

4. The wiring compartment is intended as a termination point

for the audio circuit. Access to this compartment is gained by

TheInstallationIC-SW-8T2 includesGui linesa tilebridge for use when installing

the loudspeaker into suspended ceilings or wherever additional reinforcement of the ceiling material is required. The tilebridge and loudspeaker are designed such that installation may be accomplished where access above the ceiling is not possible or may be difficult.

1Installation. The tilebridge is composed of three parts—a reinforcement ring and two rails. The two rails should be attached to the reinforcement ring using the two included screws as shown below.

Caution: Be sure to comply with any and all building codes in your area.

2.To install your IC-SW-8T2 cut out a hole in the ceiling using either the cardboard cutout template provided with your speak- ers or consult the measurements below. Pull wiring through hole.

IC - SW - 8T2 12.5 "Round

removing the terminal cover located on the back of the

speaker. The terminal cover will accept the appropriate

conduit/wire adapter (provided). Feed wires through

conduit/wire adapter and connect to the input terminal

according to the desired operation mode. Be sure to observe

proper polarity. Replace the terminal cover and tighten the

conduit/wire adapter to secure the wire.

Caution: When connecting 70V or 100V distributed line systems, take care to ensure proper terminal connection. Connection to the low impedance termi- nal could result in speaker damage, amplifier damage, or both.