Kramer Electronics TP-330FW guide

Wiring the TP LINE IN/LINE OUT RJ-45 Connectors

On both TP-330FWunits:

The ON LEDs light green indicating that they are receiving power —and—

The CAT 5 LINK LEDs light green indicating that a CAT 5 link has been established between the units

Notes:

•You can connect two FireWire devices simultaneously to a TP-330FW, however, only one device can be active at a time

•There is no need to install the Kramer PT-1FWDV Line Protector on the STP/UTP as the TP-330FWalready contains built-in line protection

•You can connect devices with 1394b (FireWire 800) bilingual interfaces at speeds of up to 400Mbps. The FireWire cable used must have a bilingual connector on one side and a 1394a 6-pin connector on the other side

6 Wiring the TP LINE IN/LINE OUT RJ-45 Connectors

Table 2 and Figure 3 define the TP RJ-45 wiring that is different to the standard EIA/TIA 568B wiring. When using STP cable, connect/solder the cable shield to the RJ-45 connector shield.

Table 2: Twisted Pair Cable Wiring

PIN		Wire Color	PIN
1	Green/White		7
2	Green		8
3	Orange/White		3
4	Blue		4
5	Blue/White		5
6	Orange		6
7	Brown/White		1
8	Brown		2

1 234 5678

4 5

Figure 3: UTP Connector