5.Insert the speaker into the cutout hole. With a #2 Phillips screw- driver, tighten the four dog clamps until they are seated securely against the ceiling surface. Do not overtighten.
6.For installations using the 70/100V input connection, set the switch on the front panel to the desired tap setting. For applica- tions where16 Ohm impedance is desired, the switch should be set to 16 Ohms. Note: The speaker comes from the factory set at the lowest output setting (highest impedance).
7.The
8.Using the flat of your hand, insert grille into speaker frame making sure it is securely seated and flush.
Seismic Tab
A seismic tab, located on the back of the speaker, is used as a secondary security point. Some construction codes may require its use. To utilize the seismic tab, run a support wire from a secure point in the ceiling and attach it to the tab. Be sure to consult the construction codes in your area. Klipsch recommends the use of this tab in all installations as a secondary means of support.
70V
100V
70V
60
100V
