Kenmore 37035, 216.31703, 216.3703 owner manual To Remove Belt, To Replace Belt or Brushroll

i WARNINGI

Electrical Shock and Personal

Injury Hazard

Disconnect electrical supply

before servicing or cleaning

the unit. Failure to do so could

result in electrical shock or personal injury from vacuum cleaner suddenly starting.

TO REMOVE BELT

Lay cleaner flat and flip cleaner to expose nozzle base. To remove nozzle guard, slide lock A to unlock position, to the left. Then depress lock B to unlock nozzle guard°

Rotate/pivot the nozzle guard and pull off

Lift and remove

brushrolL Dispose of old belt.

TO REPLACE BELT OR BRUSHROLL

Place new belt in area

of brushroll without bristleso

shutoff pedal in

__Place brushroll "Carpet" position..

shaft. Ensure to loop

the belt around the

j__Slide belt ontomo to r belt lifter shaft.

With new belt in place, pull and slide brushroll into nozzle making sure that the brushroll

end caps are in the correct orientation (see diagram for end cap orientation). Rotate brushroll manually

to make sure belt is properly aligned.

Secure by aligning

the three (3) tabs in the base slots.

To reattach nozzle guard, rotate/pivot back into position°

To secure nozzle guard, push lock B down to lock position. Slide lock A into lock position, to the right.

A

13