Kenmore 580.75051 owner manual Display

DISPLAY

V TEMP A "---

O

ENERGYSAVER

REMOTE CONTROL SIGNAL RECEIVER

TEMPERATURE SETTING

•Use this button to automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by increments of I°F.

ENERGY SAVER

,The fan stops when thecompressorstops cooling. Approximatelyevery3 minutesthe fan will turn on and check the roomair to determineif coolingis needed.

DISPLAY COOL/FAN

•Everytime you push this button, it will toggle between COOL and FAN.

MODE	COOLFAN 0	ON/OFF TIMER
I		SHUT-OFF TIME
		• You will usuallyuse shut-offtime while you sleep.
		• If unit is running, Timer sets number of hours until shut-off.
TIMER		• For your sleeping comfort, once Timer is set, the Temperature
ON/OFF		setting will raise 2°F after 30 min., and once again after another
		30 min.
		• Every time you push Timer button, it advances the Timer setting
FAN		as follows: 1 Hour _,2 Hours _,etc. _ 12 Hours maximum.
		START TIME
SPEED
		• If unit is off, Timer sets number of hours before unit starts.
HI/LO		• Every time you push Timer button, it advances the Timer setting
		as follows: 1 Hour _,2 Hours _, etc. _, 12 Hours maximum.

POWER

•To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.

•This button takes priority over any other button.

•When you first turn it on, the unit is in cool mode, High fan speed, Temperature setting at 72°F.

FAN SPEED

•Everytime you push this button, it advances the setting as follows: {High(F2) _, Low(F1) _,High(F2)}

•__ _-lltfoJ_J_1:f;i__--

In failure of electric power, the unit runs as previous setting operation.

-10-