Service and Adjustment (cont'd)
Element Cleaning/
Replacement (cont'd)
7.Disconnect the two wires on the element and unscrew the old element from the tank.
12.Open the cold water supply valve to the water heater. NOTE: The cold water supply valve must be left open when the water heater is in use.
13."Ib insure complete filling of the tank, allow air to exit by opening the nearest hot water faucet. Allow water to run until a constant flow is obtained. This will let air out of the water heater and the piping.
8.Clean the area around the element opening. Remove any
sediment from or around the element opening, inside the tank.
9.If you are cleaning the element you have removed, do so by scraping or soaking in vinegar or a
AWARNINGI
Replacement elements must (I) be the same
mode rat ng p ate affixed to the water heater.
10.A new gasket should be used in all cases to prevent a possible water leak. (See Element Gasket in the "Parts Order List"
Chart). Place the new element gasket on the thread side of the cleaned or new element and screw into tank, securing tightly using an element wrench.
11.Close the water heater drain valve by turning the handle to
the right (clockwise). The drain valve is on the lower front of the water heater.
A CAUTION | J |
Never use this water heater unless it is completely J full of water. To prevent damage to the tank and J heating element, the tank must be filled with water. J Water must flow from the hot water faucet before turn ng 'ON 'power.
14.Check element for water leaks. If leakage occurs, tighten element or repeat steps 2 and 3, remove element and reposi- tion gasket. Then repeat steps 10 through 14.
15.Reconnect the two wires to the element and then check to
make sure the thermostat remains firmly against the surface of the tank.
£
16.Replace terminal cover on thermostat and fold insulation back over the element.
16