VCR Playback to the Monitor
To view a recorded tape through the monitor, follow these steps.
1.Turn on the monitor and the VCR.
2.Press VCR on the monitor's front panel. The VCR indicator lights.
3.Begin playback on the VCR.
4.When you finish playing the recorded tape and have turned off the VCR, press AUTO to return to sequential camera scanning
ˆCare
Keep the monitor dry; if it gets wet, wipe it dry immediately. Use and store the monitor only in normal temperature environments. Handle the monitor carefully; do not drop it. Keep the monitor away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
Modifying or tampering with the monitor’s in- ternal components can cause a malfunction and might invalidate its warranty and void your FCC authorization to operate it. If your monitor is not performing as it should, take it to your local RadioShack store for assis- tance.
TROUBLESHOOTING
If your monitor is not working as it should, these suggestions might help you eliminate the problem. If the monitor still does not op- erate properly, take it to your local Ra- dioShack store for assistance.
No picture appears.
•Be sure the monitor's power is on.
•Check the connections between the camera and the monitor. Be sure audio and video cable connections are not reversed and that power connections are secure. Try all the CA jacks on the rear apron of your monitor.
•Adjust CONT.
Image is not clear.
•Adjust CONT.
•Adjust BRT.
•Adjust
•Be sure the selected camera is not pointed directly at a light source.
Cannot record to a VCR.
•Check the cable connections. Be sure audio and video cables are not reversed.
•Be sure the VCR is set to audio/video input and is set to record.
•Check the connections between the camera and the monitor.
Cannot play back using the monitor.
•Check the cable connections. Be sure the audio and video cables are not reversed.
•Be sure the VCR is set to play.
6 | Care |