Dakota Alert Dakota Alert, DCMT-2500 owner manual Off

Coding the transmitter:

Note: The transmitters and receivers are preset at the factory. DO NOT change settings, unless changing the tune or experiencing false signals.

1.Locate the dip switches in the DCMT-2500 circuit board (Figure 5).

2.The first eight dip switches are for the frequency setting (256 combinations). Set switches 1-8 (Figure 5-3) to match the eight switches in the receiver.

3.Switches 9 and 10 (Figure 5-4) are for the zone/channel settings on the transmitter. The four zones are listed in the table below.

{ {

Switch 9	Switch 10	Channel	Tune
On	On	1	Classical
Off	On	2	Westminster
On	Off	3	Ding Dong
Off	Off	4	Whistle

3 4

Figure 5

LOW BATTERY ALERT: If the receiver sounds a second alert 30 seconds after the first alert, provided nothing activates the transmitter again, the 9-volt battery in the transmitter should be changed.

8.