D-Link user manual Ⅰ. Introduction, Ⅱ. Mounting configuration of DCS-50

Model No.: DCS-50 User’s Manual

Ⅰ.Introduction

The DCS-50 Camera Housing is constructed from die-cast aluminium and is powder coated and stove finished.The design and manufacture is to the highest technical standard with environmental protection to level IP 66. The Housing is supplied complete with an adjustable

Semi-Cable-Managed Mounting Bracket.

Ⅱ. Mounting configuration of DCS-50

(D)

(E)

Fig.1

(B)

Fig.2

1.Use the rear section of the Mounting Bracket (D) as a template for marking the position on the wall of the Mounting Holes (H). Remove & drill to pattern required.

(K)2. Attach the Mounting Bracket arm to the wall using the rawlplugs and screws provided.

	3. Attach the main Housing enclosure (K) to the
	Mounting Bracket with 2 of 1/4” x 14.7 mm
	Trilobular screws (F) provided.
(G)	4. Release Screw (E) on the Mounting Bracket to
(F)	pan the Housing and release screw (G) to tilt the
	Housing. Position the Housing as required for
	the correct Camera coverage then tighten both
	Screws to secure.

5.Feed cables through the Cover Plate (B) on the Mounting Bracket from the wall, or by using cable conduits as required.

90° 90°

65

(H)

78

Inner space for camera mount W90 x H70 x L230mm

1