Vivotek FD7130 Network Deployment, Power over Ethernet PoE When using a PoE-enabled switch

Page 10

English

5Network Deployment

Power over Ethernet (PoE)

When using a PoE-enabled switch

This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE-enabled switch via Ethernet cable.

PoE Switch

When using a non-PoE switch

Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.

PoE Power Injector

(optional)

Non-PoE Switch

EN - 9

Image 10

Contents Quick Installation Guide Contact your distributor in the event of occurrence Do not drop the Network Camera Package Contents Inner View Physical DescriptionOuter View Cabling Assembly RJ45 Cable ConnectorM12 Cable Connector Hardware Installation Ceiling MountInstalling the Ground Wire Wall MountWhen using a non-PoE switch Power over Ethernet PoE When using a PoE-enabled switchNetwork Deployment Assigning an IP Address Network CameraTo adjust the viewing angle Adjusting the LensReady to Use Completion Fine-tune the Camera Focus