Allied Air Enterprises 506299-01 warranty Operating Your Unit, Lighting Instructions, Gas Valves

Page 3

OPERATING YOUR UNIT

These units are equipped with an ignition device which automatically lights the burners. Do not try to light the burners by hand.

Before operating, smell around furnace area for gas. Be sure to smell near the unit base because some gas is heavier than air and will settle to the lowest point. See WHAT TO DO IF YOU SMELL GAS on page 1 if the odor of gas is present.

Use only your hand to slide the gas control switch; never use tools. If the switch will not move by hand, don’t try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.

Lighting Instructions

1.STOP! Read the previous safety information.

2.Set the thermostat to the lowest setting.

3.Turn off all electric power to the unit.

4.Remove the burner compartment access panel.

5.This appliance is equipped with an automatic ignition device. Do not try to light the burners by hand.

6.Turn the gas control knob, or slide the gas control switch, to “OFF” (see Figure 1).

Gas Valves

Gas

Control

Knob

Gas Control Switch

Figure 1

7.Wait 5 minutes to clear out any gas, then smell for gas (including at the bottom of the unit near the ground). If you smell gas, stop and follow the directions in WHAT TO DO IF YOU SMELL GAS on page 1. If you don’t smell gas, continue to next step.

8.Turn the gas control knob, or slide the gas control switch, to “ON”.

9.Replace the burner compartment access panel.

10.Turn on all electric power to the unit.

11.Set the thermostat to the desired setting.

12.If the unit will not operate, follow the instructions found below in To Turn Off Gas to Unit and call your service technician or gas supplier.

Operating Sequence

When the thermostat calls for heat, the vent motor will purge the system for 30 seconds (nominal). When the prepurge time has expired, the gas valve will open for direct ignition. When burners are lit, the flame sensor will sense flame and keep the gas valve open. If the flame sensor does not sense that a flame has been established, it will shut off the gas valve. The ignition system is designed to go through three trials for ignition. If flame still has not been established after the third trial, the system will go into lockout. After 1 hour, the system will try three more times.

If the system goes into lockout, it can be reset by turning your thermostat down or off for 10 seconds and then back to the desired point.

When the room thermostat is satisfied, the electrical circuit to the gas valve is opened and the burners are shut off.

Shutting Down the Unit

To shut down the unit, set the thermostat to the “OFF” position.

To Turn Off Gas to Unit

1.Set the thermostat to the lowest setting.

2.Turn off all electric power to the unit if service is to be performed.

3.Remove the burner compartment access panel.

4.Turn the gas control knob, or slide the gas control switch, to “OFF” (see Figure 1). Do not force.

5.Replace the burner compartment access panel.

506299-01

Issue 0912

Page 3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents RPGE/RGE Series Table of ContentsElectrical SHOCK, Fire Or Explosion Hazard Important Safety InformationOperating Sequence Operating Your UnitLighting Instructions Gas ValvesTemperature Control ThermostatUnit Operation Maintenance of Your Unit Combustion and Ventilation AirVenting and Unit Support Filters Blower AssemblyRollout Switch Return AirRepair Parts Failure to Maintain Your Equipment will Void this Warranty Allied AIR Enterprises Equipment Limited WarrantyRequirements for Extended Coverage Year Limited Extended Parts WarrantyIssue 506299-01

506299-01 specifications

Allied Air Enterprises has established a strong reputation in the HVAC industry, and its model 506299-01 continues this tradition of excellence. This unit stands out for its advanced engineering and innovative technologies designed to provide optimal comfort in residential and commercial settings.

One of the main features of the Allied Air Enterprises 506299-01 is its highly efficient operation. With a superior SEER (Seasonal Energy Efficiency Ratio) rating, this model ensures lower energy consumption while maintaining maximum cooling output. This not only contributes to a reduced carbon footprint but also leads to significant savings on energy bills for consumers.

The design of the 506299-01 incorporates advanced compressor technology, allowing for quieter operation while delivering powerful performance. This is particularly valuable for users who prioritize maintaining a serene indoor environment, as the unit operates with minimal noise disturbance.

In addition, the model is equipped with a multi-speed blower, enhancing airflow control and distribution throughout the space. This feature ensures that every corner of the room receives consistent temperature regulation, improving overall comfort. Furthermore, the unit's compact design makes it easy to install, even in tighter spaces, without compromising on efficiency or performance.

Durability is another hallmark of the Allied Air Enterprises 506299-01. The unit is constructed from high-quality materials, ensuring longevity and reliability under various operating conditions. This durability is complemented by a robust warranty, giving customers peace of mind regarding their investment.

Another notable characteristic is its smart technology integration. The 506299-01 is compatible with modern HVAC control systems, enabling users to automate their heating and cooling preferences through programmable thermostats or smart home systems. This not only adds to user convenience but also optimizes energy efficiency further by allowing precise control over heating and cooling cycles.

In summary, the Allied Air Enterprises 506299-01 is a testament to advanced HVAC technology, combining energy efficiency, quiet operation, and durability with modern convenience. Its thoughtful design makes it a reliable choice for anyone looking to enhance their indoor climate control capabilities while being mindful of energy consumption and overall efficiency. As such, it represents a valuable addition to any home or commercial environment striving for ultimate comfort and sustainability.
Top Page Image Contents