Operation
Frequency Interference
If the fireplace does not respond properly to the remote control, the remote operating frequency may have to be reset. The remote control can send another frequency code to the circuit board to eliminate interference.
1.Simultaneously press the
“Temperature Down” button and the “Flame Speed Down” button on the remote control (Figure 7).
2.“COD” will appear in place of the sleep timer digits.
3.Release the “Temperature Down” button and the “Flame Speed Down” button.
4.Press the Initialization Button on the unit (Figure 5C).
5.Press the Flame/Heat On/ Off Button 
button on the remote.
Your remote will now have a different frequency communicating with the fireplace.
Remote Control Functions
(All letter references are to Figure 7)
B. Set Temperature
Press F button 
to turn fireplace on.
Press H to raise thermostat. Press G to lower thermostat.
Press both H and G to change °F to °C.
C. Dimmer 
Press the F button 
to turn the Flame/Heat on.
Repeatedly press the J or I button to decrease or increase the brightness of the upper lights.
D. Flame Speed 
Press the F button 
to turn the Flame/Heat on.
Press the L button to increase the speed of the flame.
Press the K to decrease the speed of the flame.
E. Sleep Timer
The Sleep Timer automatically shuts off the fireplace after a preset time (from 30 minutes to 8 hours).
Press the F button 
to turn the fireplace on.
13